BUNKER INDUST Flush Mount LED Light Pods 5 Inch LED Work Light Bar Pair 48W Driving Bumper Lights Flood Spot Combo Off Road Fog Lights Waterproof for Tractor Truck ATV UTV Golf Cart

These are nice there bright but not to bright which is good for using as fog lights

Excelente luz muy buena nitidez

I like that these lights fit in the space inside my work truck.

Shallow mount is very versatileWiring could be improvedWorked great but didn't put up with the tree as well as the Steelcraft bumper did.

Took longer than expected to install ended up having to get help

Haven’t installed yet, too cold. However I tested them and they are super bright. Excellent construction and the price is far better value than any local retailer. I’m very happy with this purchase and can’t wait to install them !Update lights are now installed on my 1999 Kawasaki Mule.~ I used The original head lights casings. These were meant to be disposable after bulbs die..~I broke out the glass etc until all that was left was the black rubber housing.~I cleaned housing with Denatured Alcohol to ensure excellent adhesion.~Applied silicon around the putter front rim or housing.~Lastly, the LED light was placed on top of silicon bead and left over night to dry.**note this ensured entire light assembly is in water proof housing.WIRING ASSEMBLY~I made extension pigtails from the lights and installed male and female butt connectors to Red & Black wires.~this Was done prior to setting light in silicon~ the extended wires made connections a breeze~ KEEPING IN MIND to keep housing waterproof.A: all wires were heat shrunk in 4 inches of black shrink tubes.B: Then the split ends were shrunk individually and Over the ends of the butt connection.C. After cool, wires went through existing wire opening on bottom.D. silicon was applied Rim and also to the opening on bottom for wires; This makes housing now completely water tight.

I had a limited space to put lights, these fit just right, nice and bright , I use them as driving lights

remove the fog lights, unplug/cut the connector off, the colored wire is positive. The light will go to the back of the fog light hole and use some 1 5/8 dry wall screws to mount. They are very bright. I can't wait to run them at night after I convert them to straight fog lights. They do look pretty good.