4mm Birch Plywood A4-300x210x 4mm - (Pack of 4) - Laserable Low fume E1 Glue Ply...

Nice finish and warp free product.

Excellent service 10/10

Have purchased smaller quantities in the past with poor results and assumed I just had a 'bad batch'.I recently purchased 100 sheets to fulfil a project which needs to be completed by the end of the month but am not able to produce the desired quantity.Each sheet was intended to yield 1 set of puzzle pieces but more than half of the pieces were not cut properly and had to be scrapped.This meant that I have had to mix and match pieces to make complete sets and because the thickness of the sheets varies quite a bit (3.65 mm to 4.15mm) each set now has inconsistently thick pieces.In total I have laser cut 75 sheets so far which has yielded just 35 sets of puzzle pieces.This is a scrap ratio of 14:11 (56% scrap/44% good).Effectively, each set is costing £2.85 instead of the expected £1.33.I can't fault the surface finish. Most of the sheets have an incredible finish and would be suitable for most craft projects but I would certainly not recommend for laser cutting.

It's high quality 4mm plywood. Nothing else to add!

Overall a very good product, delivered quickly and well packaged.Didn't have any defects and all pieces were smooth with well cut edges.However some pieces did have slight warp but nothing that prevented them being used. I assume this occurs to varying degrees in most of the plywood bundles available online.

Product it good but it was not left in letterbox as driver put on here, he actually handed it to me in person!! Why do they constantly do this????!!!

Bought to use with my new Xtool M1 10W laser. Cuts cleanly in a single pass at 2mm per sec and 100 percent power.

As it says in the title, the sheets arrived warped with a roughly 2mm deviation across the short edge. This renders them all but useless for their intended application (box making). I’ve given them 2 stars because they seem decent in other respects; I can’t see any edge defects and surfaces look clear. It’s just a real shame that the warping basically makes them scrap.I would recommend these perhaps for certain art and craft purposes, if you have a use case where dimensional stability isn’t such an issue. Otherwise, look elsewhere.