EEMB 3.7V Lithium Polymer Battery 2000mAh 103454 Lipo Rechargeable Battery Pack with Wire JST Connector for Speaker and Wireless Device- Confirm Device & Connector Polarity Before Purchase

Order the reverse polarity option if ordering for a RAK Wisblock device. I’m building my first Meshtastic device little by little. Getting all the hardware how I want it then will figure out a case. My Wisblock has the GPS module and environment sensor module installed. This battery fits my needs perfectly. Quality seams good. Haven’t yet tested its battery life but I expect it will last and least 24 hours. Longer without a screen or with the screen set to turn off after some time.

good choice

Exactly what I ordered!

Ordered for use with some RAK WisBlock Base Boards. After reversing the plug polarity so it matches the board, the batteries do work to power the board, and charge when the board is connected via USB. Unfortunately in spite of them having a BMS, three of the four batteries have swelled dramatically during the first three or four charging cycles. Straight from the box, they measure 9.37mm thick. The first battery is noticeably bulging and measures 10.85mm after being put through a few charge/discharge cycles over the course of a few days.The second one I tried, in the hopes that the first one was just defective, swelled to 9.8mm after just a single day, being charged by the RAK.The third one I've placed on my bench power supply with the CV/CC settings on 4.2v @ 1.0A (0.5C -- half what the Amazon product page says the battery is rated for; the battery itself is not marked with charge capacity information, nor is it printed on the including documentation. After charging this way for only 45 minutes, while still drawing ~500mA @ 4.2v, it has already swelled by 0.1mm.Will not be buying this brand of battery again, and all of these are getting recycled.

Works well. I have a potensic P5 drone. It's an older model. So the batterys are extremely hard to find. But with this purchase, I was able to open the old battery and desolder. The old swollen batterys and replaced them with these. Not it works perfectly and lasts longer. If you don't have experience with soldering ask someone who does. But even with basic knowledge I was able to do it. These batteries are good for lots of other projects too. They are a good value. Just check all the requirements for the product you are working with. And don't just throw a battery on it.

The connector does not fit Heltec v3 LoRa32. But you can cut off the wires and solder on the correct connector, which for me at least, came in the Heltec original box.

Included in the package was a "Buy this at our website and its 20% cheaper!". It wasn't. It was $3.99 more expensive.

As per any product from "Li-time that I have bought; I really do not have any complains, I have just compliments and commendations. The very best!