Detroit Axle - Front End 12pc Suspension Kit for 2004-2009 Mazda 3, 2006-2015 Mazda 5, 2 Lower Control Arms w/Ball Joints Inner & Outer 4 Tie Rods 2 Boots Front & Rear 4 Sway Bars Replacement

Edit 2020-09-25:Well quality is somewhat questionable. One of the rubber covers on sway bar links cracked. There is a occasional weird noise come when turning the steering wheel. So may have to check/replace some of these parts this year or next year.2010 Mazda 5.Replaced Lower Control arms and Sway bar links using this kit.Was going to change wheel bearing and since I took everything out thought to replace the warn ball joints. But after seeing the price of the whole kit, thought to replace the whole arms along with ball joints and bushings etc.Now the car drives really well.Had to get an alignment done after.No complaints, this was the first time I replaced these parts. You definitely need to rent Ball Joint Separator, Tie rod Arm Puller/Pitman Arm Puller from Auto Parts retailer. I used1. Powerbuilt Tools Kit 43, Reversible Gear Jaw Puller Kit (Part # 648613): used the largest one to push the front axel away from the hub assembly. Grab the rotor with 3 arms and push the axel with the screw/center rod of the puller.2. Powerbuilt Tools Kit 3, Front End Service Kit (Part # 648626): to separate the ball joints from the arms.Don't use hammer or any other tool to bang/strike or split as shown in many Utube videos. That will damage parts, I learned it hard way. With above tools you can get the job done quicker & easily. Plus they are free (once you return the tool back to the store)

Included in this kit are the following 12 parts (this list should really be in the product description as 2 of the parts are for the REAR sway bar):K80867 Both (2) Brand New Rear Stabilizer Sway Bar End Link – Driver and Passenger SideK80235 Both (2) Brand New Front Stabilizer Sway Bar End Link – Driver and Passenger SideES800025 (1) Front Outer Tie Rod End Passenger SideES800026 (1) Front Outer Tie Rod End Driver SideEV800024 Both (2) Front Driver and Passenger Side Inner Tie rod EndsK620040 (1) Front Lower Right Control Arm & Ball Joint AssemblyK620041 (1) Front Lower Left Control Arm & Ball Joint Assembly??????? (2) Bellows and metal zip tie for steering tie rods, Driver and Passenger SideEverything fit flawlessly and easily on a 2007 Mazda 3 S Wagon. The hardest part is typically removing the old parts to put these on.

Part fit perfect. Very easy to install. Came in very fast.

It seems to be a good product but had one little issue on one of the lower control arm. One of the bolts was not fitting correctly into the nut had a Welding spot keeping the bolt from screwing in had to grind it off spending more time fixing the part than replacing the part. Check all bolts before you start replacing parts.

Shipping was fast (I live in Detroit), parts arrived in decent packaging. Installed both lower front control arms & ball joints (current ones had about 170k on them, and were pretty loose). Less than 2,000 on the new ones, and the driverside ball joint has gone bad already. Terrible quality. Going to be pursuing warranty/refund, but we'll see if there's any response. There's cheap - ok parts, and then there's cheap - trash parts. These are the latter.

Came on time and part was the same ♥️

slight installation difficulties, fixed by grander.one rubber band is damaged, forgot to take a photo. bolts did not fit, left the old ones. steering rod anthers did not fit, left the old ones

Lo recomiendo mucho