Godmorn Stovetop Espresso Maker, Moka Pot, Percolator Italian Coffee Maker, 600ml/20oz/12 cup (espresso cup=50ml), Classic Cafe Maker, stainless steel, suitable for induction cookers

I've had this for about a month now and it is better than expected for the price, though I see that currently Amazon has doubled the cost of what I paid for it!I've had a number of moka pots over the years, mostly Bialetti (the original moka pot) and Cuisinox. I recently dropped and bent the rim of my Cuisinox Liberta 10-Cup pot and it would no longer hold the steam. I ordered one of the larger Bialetti pots, but there was what looked like loose metal plating on the internal funnel/filter. I returned it and the replacement had the same issue, so I decided to try one of these Chinese made off brand models - there seem to be several on Amazon that are the same but under different brand names. It was half the price of the defective Bialetti and a third of my old Cuisinox, I was a bit skeptical of the quality of a cheap brand, but it seemed worth a try for the price.I was even more skeptical when it arrived, the stainless steel is of a lighter gauge than either the Cuisinox or the Bialetti and kind of felt flimsy in comparison, but thus far have had no issues. In some ways its even an improvement on the old Cuisinox - the handle is cooler and it doesn't drip when I pour the coffee. The Cuisinox always dripped a little over the edge and spilt some coffee. I got the 600ml/20oz/12 cup version, which provides 2 big mugs worth of almost espresso coffee per pot.So far no issues, no rusting or corroding as some have reported. The upper gasket and filter are a little loose, but haven't fallen out of the top half yet. I'll be getting some replacement gaskets for the future, as that is the only thing that goes wrong with these moka pots - unless you drop and bend them!

Update: I've been using this just about daily for 3 months, still makes good coffee. The things I've noticed isfirst the lid isn't very easy to open with the little tab, it doesn't provide enough leverage for easy opening. While it does have a pour opening in the lid pouring out coffee isn't a problem, only after pouring the coffee I like to open lid and rinse out the remaining coffee/grinds left behind in the top part.Second thing is I notice the handle is getting lose. It seems the screw isn't tight. I never use the handle to remove top from bottom, always grab the top and bottom to loosen and remove. The only thing I've used the handle for is to set on stove to perk and then to pick up and pour. Likely just needs the screw tightened, maybe some lock tight on the threads would stop that in the future.Otherwise still makes a good 12 ounce mug of coffee. I really wouldn't call this (or anything similar to this) an expresso maker, it's is just like a percolator only the water passes through the grinds just once instead of many times. Which is why needs more grinds then a percolator which passes the water through the grinds many times. Like a percolator the top is open to room pressure air so this doesn't send high pressure water through the grinds any more then a percolator does. But if just want one 12 ounce mug of coffee then this is great way to go. With just making 12 ounce mug it takes around 5 minutes to make. With normal morning routine start this going first then by or before have other kitchen morning routines done coffee is ready too. When I was making coffee with the 64 ounce percolator would be close to 30 minutes before coffee was ready. Big difference.---------------------------------------------Before this I had been using a percolator (Farberware 50124 Classic Stainless Steel Yosemite 8-Cup Coffee Percolator) which made very good coffee (still does) but now that I don't need as much coffee per day this espresso maker makes coffee very similar to my old percolator, perhaps slightly stronger then my usual 6 minute perc but if I had let the percolator go for a minute or two longer likely wouldn't be able to tell the difference.OK, so what it comes down to. It will make about 12 ounce of coffee per batch. Coffee flavor is depended on beans and roast used. Good beans and roast makes good coffee. Percolator used eight spoonful of grinds to make about 8 cups (64 ounces), this espresso maker uses three spoonful to make 12 ounce (1.5 cups). So it uses about twice as much grinds as the percolator per eight ounces of coffee. In both cases I just spoon in the grinds and level it out without packing the grinds down. With both I ground the beans to the same I use for the percolator (course grind). Brew time (from cold water to time ready to pour into a mug) with expresso maker is fairly quick, I didn't time it but seems around 5 minutes. with percolator about 20 minutes (larger volume of water will take longer to bring to a boil). I would allow water to come to boil first then lower the inside parts into pot and put the top on, turned the heat down to low, after first perc appeared I had set a timer for six minutes. This kept the brew time consistent with consistent results. Yeah, a lot of work for a morning cup of coffee...With the espresso maker the water is pushed out of the reservoir into the top part, it will make a sputtering sound when finished so no need for a timer. Results are consistent with the grind and beans used.For some reason after brewing the reservoir will have a small amount of very dilute brewed coffee in the bottom, if left on the heat too long this coffee residue will become a scorched, burned in mess that would be very difficult to clean. So once it finishes brewing take it off the heatLike with the percolator there was some learning curve to find what I considered best flavor coffee (perk time, grind size), so I will have to experiment with grind size and if rather or not to and how packed down the grinds need to be to make for me the best tasting coffee from it.Some things to be aware of...1 - I wouldn't consider this espresso maker as being heavy duty (is any of them?) so never use the handle to tighten or loosen the top from the bottom, likely that would eventually rip the handle off.2 - fill with water to below that thing that sticks out of the side of the reservoir, it's a safety pressure release valve. If it's covered by water it will not work correctly3 - After brewing it will be too hot to hold for a while so either wait to let it cool before trying to separate the halves or wear heat proof gloves when doing it. Dump the old grounds and rinse everything well and it's ready for next time.4 - I'm sure there may be some other things but off hand I can't think what... so whatever it is never do it... or is it always do it...For first time use I washed everything with soap, water and dish sponge to remove any oil or contaminates from the manufacturing process. Rinse well and then do a brew without grinds. When cool take it all apart and rinse well then brew your first batch of good coffee.Yep, first batch was a good tasting cup of coffee without much effort.

The media could not be loaded. The main problem I had with this was lifting the coffee holder/filter from the base - it fits so tight that I couldn't grab it even with fingernails or a knife. I would have to flip it upside down, often causing a spill. But I tried using a super strong magnet (neodymium type, can be any shape, I just happen to have a disc) and it works perfectly (see photo or video). The holder/filter is magnetic while the base is not, so it separates easily, can even do this while hot and I can then grab the edges (gingerly if hot), and lift it out and then grab by the filter spout to turn upside down and dump the grounds.Another slight complaint is that it makes just under 2 mugs of coffee. If I want 2 full mugs, I have to overfill it slightly, just under the rim (above the pressure relief valve). I would have purchased a larger size but couldn't find one on Amazon at a reasonable price. But this is really a small issue, it's close enough I could either slightly overfill or just use more creamer or live with a slightly less than full mug (about 90%).Also, it's slightly hard to screw together, so I lubricated the screw threads with olive oil and that works great, makes it easy to screw/unscrew. It takes 2 full rotations to fully screw/unscrew.Other than these issues, works great-easy to use and clean, makes great tasting coffee, recommended.

This is one handy little Moka pot! It can make a very strong or very weak cup of coffee. It was large enough to make at least 2 cups for someone who likes standard strength coffee, if you add a little water to your cup after filling. It works well, cleans easily, and is high quality. I enjoyed the somewhat slower experience of brewing rather than setting and forgetting of other methods. WE took it camping, on vacation, grilling outside.... It is easy to use just about anywhere.