YIMU Car Backup Camera for car with Monitor,Night Vision, DIY Guide Lines, IP69K Waterproof, Front/Reverse Camera with Two Beackets for Easy Install for Trucks, SUVs and Pickups K43 (5 inch)

Works fantastic !!! I wanted a forward facing camera so I could see how close I was getting to the curb to stop. And this works perfectly. Highly recommend this

Absolutely fantastic

Very nice unit for the price.

I bought this for my friend who has an old Toyota and wanted a back up camera set up was pretty straightforward. Drove the hole in the trunk to get the wiring in and decided to run it through the cigarette outlet just to avoid having to wire it up.

Works great and very simple to install

Put this on a Case JX70 to see the rear implement. Was very easy to install with all wiring included. Great picture and adjustment for definition are very good. Can not beat the price for this little screen and camera.

I purchased this backup camera in February. Unfortunately I did not start installing it until April. When I was feeding the wiring harness from the display unit to the camera, the connector tip pulled right apart into two pieces separating the wires from the pins that connect to the camera wire. There was no way to plug the tip back in and have the wires properly connected. Since this was beyond the Amazon return time, I emailed the manufacturer at the customer service email address listed in the product material included with the camera. I asked them how I could get a replacement wiring harness so that I could install the backup camera into my car. They never responded. I have had issues in the past with other products from other sellers and their customer service has been great. Unfortunately this company’s customer service is useless and never even responded. Now I am stuck with having to purchase a complete new backup camera system just because of this defective wiring harness. If the back up camera works for you, great, but don’t assume there will be any customer service help from the manufacturer if you have any issues.

Installed as a front vision camera. The license plate mount would make the camera vulnerable to being destroyed by automatic car wash brushes. I fabricated a "behind the grill" mount to minimize this problem. I also install a rocker switch and connected the power to accessory power just to complicate things. Now I can turn it on when I need it without it using power if I forget to turn the switch off. Installation should only be attempted by a well informed, handy with tools individual. If possible, recruit a helper.