WIN TAPE Workbench Ruler Adhesive Backed Tape Measure 60inch 152cm (Left to Right - Inch/cm)

This is exactly what I was looking for to adhere to my folding hobby table. Its thin enough to cut and easy to apply. I don't know how long it will last or how well it will stay on long term but so far I'm pleased. I compared the measurements to my omni grid ruler and it is accurate. When I first opened the bag it looked like there were a lot of air bubbles in the tape but once you peel the backing and apply, the air bubbles disappear and it smooths out nicely.

I bought this to put on along the front workbench which has a laminate countertop. I Should have done this years ago. It has already come in handy often especially for when you need a quick measurement without having to dig for a handheld tape measure. I installed it on my bench in a Midwest winter when the temp was in the 20s in an unheated garage. It adhered just fine. I did run my low temp heat gun across it before my final pressing to help insure it will stick semi-permanently. Dont know if that helped or not but it has adhered great. I like the fact that it's a thin film which doesnt have a thick edge to catch when I'm cleaning the bench. The hash Mark's are well defined in good contrast. I expected some stretching from pulling it tight during installation, So I checked the measurements on the tape with a machinists ruler....both SAE and metric and it is dead on. Highly recommended.

I like it. It is like a metallic type paper so was a pleasant surprise.

I was pretty enthusiastic about this tape when I first applied it. However, in very short order the numbers and hash marks began to fade and wipe during regular use. No sanding or harsh chemicals. Just casual use. After a few months it’s nearly unusable. I haven’t peeled it off yet because I tested the corner on the end and it’s going to leave a sticky nasty mess when I try to remove it.Great idea, great use case for so many applications, however not durable at all.

Works well on my work bench. I no longer need to look for a tape measure and stretch it out. I can take measurements much easier.

Just a note in regards to this tape being inaccurate. If you just peel off the back and slap it down it probably will be. Instead when you install it run a metal tape measure next to where you plan to stick this. Peel the backing off a little at a time and adjust to match the tape measure as you go. It has some stretch so you can either pull it a little tight or let it slack a little. It will still lay flat and be accurate.

Perfect for my sewing cutting table.

I’m a quilter and needed a quick way to measure large cuts of fabric. This ruler is perfect. I was concerned if it would be flat enough and it is. It’s easy to apply and is securely adhered to the table. I really like it.