Throttle Body Spacer For 2009-2018 Dodge RAM 1500 2500 3500 5.7l v8

Spacer fit perfectly on my 2017 ram 1500 sport 5.7l screw were a bit tight but spray some wd40 in the holes on the intake and they go right in added a little bit of hp gain not much

Went in smooth. Looks similar to other brand name spacers. Has vortex design inside. Easy install. Def a little power gain when you're on the pedal. My truck is tuned and some mods like cold air intake etc. so the combination of all parts is helpful or else results may be negligible. Sounds cool, q bit throatier...

Pretty easy to install even though it didn’t come with an instruction manual. Bolts that come with it are 10mm instead of the 8mm that fit on the truck, they still work but if you decided to take it off you will need to find shorter 10mm bolts. Over all good product. I did felt a little bit of a difference in performance after installing. I would buy it again.

Screws are a hair to long. I think it helped millage and power,quicker response.

I definitely noticed a different after I installed this on my dodge charger. It is very easy to install with and it took 20>30minutes to install..You can tell that this is also not cheap quality and it came with the required screws which helps a lot.

2012 Jeep Grand Cherokee 5.7 Hemi. Had to cut off guide studs on upper air intake manifold (the one for the two holes on the back side of the spacer) because they were not machined correctly to line up with the bolt holes, kept it from bolts going in at all. Once guide studs cut it lined up perfectly. Definitely noticeable difference on the low end throttle… look it’s not nitrous or a supercharger don’t expect anything wild, but I paired mine with (previously installed) 2 Gibson MWA in place of the suitcase muffler, kept rear resonators, AEM dryflow air filter, Accel coil packs, MSD iridium plugs. This spacer was last thing and it did make a difference. Oh your air housing in front of the throttle is going to move out the width of the spacer so you won’t be able to bolt it down. Otherwise great product!11/2023 Follow up, this product does actually help, but if your like me it’s only covering up the true problem, you need a new alternator, battery and a tune up, my alternator was factory, 11 years old, battery 5/6 but still seemed great, truck started right up until it didn’t, click no turn, was told it was the starter…replaced alternator with 220 amp version and new battery 900cca, zero issues with starter, no more downshifting issues, especially between first and second. Accelerates better than new Look this motor has 16 plugs, 16! Alternator is the heart of everything electrical… spark, electrical power steering, efi, radio etc all at once, 180amp won’t do it, start with that before looking for miracle cures for a fraction of the price.

So the actual plate looks good but the screws that come with it are not even close to correct thread with that been said they are also to short even if they was right thread and I have looked at Lowe's, home depot, hardware, and everywhere and can't find any screws with right thread m6-1.00 and they have to be atleast 3 1/2 inches Wich like 88mm or something but can't find any above 3in 75mm so I more than likely be returning without even getting to actually try it bummer

Easy install. Takes 5 minutes. Power difference. Maybe. Deeper sounds. Smoother low end band little mpg increase