EQINI Sensor Bar USB for Wii/Wii U/PC, Black

It works no hassle have not tested it finely but seems good enough and ive had no problems the nintendo original didnt give me before i lost it only thing is heads up the sensor comes with a stand that it connects to but the stand connect to your table with this strip of sticky solid idk what it is not knowledgeable enough to sayFor the reviews sakeNo apparent lagAnd seems sturdy enough

Works flawlessly! It was exactly what I was looking for, I use this with my Wii connected to a projector and it eliminates the need to plug the sensor bar into the Wii. Any old USB A wall power adapter will work just fine.

Muy buena la he utilizado con el emulador de dolphin y no ha dado problemas, lo único malo es que el cable se siente poco resistente pero si se tiene cuidado no debería haber problemas

My Mayflash DolphinBars worked great for having both bluetooth sync and IR sensors. Well... until the stopped working. Having replaced one for the IR LEDs burning out, only to have the second one suffer the same early fate, I decided to give this sensor bar a shot.For one, the DolphinBar has 5 LEDs on each side, while the Nextronics only has 3 on each side. When comparing the two using my cell camera, the Nextronics LEDs do seem a little brighter. One thing I can say for sure is that the Nextronics sensors are detected by my Wiimote much better than the DolphinBar. I can easily step back more than 10 feet without the sensitivity cranked all the way up.Best of all, the Nextronics sensors don't get hot like the DolphinBar did (which I believe led to the early LED death). Hopefully this one will last!

When I installed it, it worked fine. I went to go use it a few days later and half of the sensor bar is out. It's just been sitting on a TV. All it is is two sets of LEDs. How they managed to make it that unreliable is beyond me.

I used this for pointer controls for Dolphin & for my Wii. Having it run off of USB power is very convenient, I can just plug it in to an old low current USB AC adapter, I don't need to have a Wii to plug it in to.

I got this for my husband for when he plays Call of Duty on Wii U. He doesn't like using the gamepad as a controller, so he uses the standard wii remote with the nunchuck. However, if I'm watching tv, he will use the gamepad as a screen and use the wii remote as his controller. This works just fine except the wii cuts off power to the sensor bar when the game pad is in use. This sensor bar was the perfect solution. We just plug it right into the back of the Wii U in the USB slot and now my husband can play on the gamepad but using the wii remote.

You can't really say this too often with knock offs, but this one was honestly more responsive and better than the original. I have tried a few in the past with limited success so if you are looking for one that will last and also improve range and sensitivity then I would recommend this one.