Hogue HandAll Beavertail Rubber Grip Sleeve for Sig Sauer P320 Full Size 9/40

Very good fit nice quality I have them on a few of my pistols

I use Houge grips on all my grips. They provide awesome grip, (also like the finger groves) add a little size for my big paws and what I love the most is they cover the beavertail. It make shooting a lot more comfortable. Highly recommended. Thanks Houge for the perfect solution.

I have an older Sig P320 carry and with slightly longer than average hands, I never found the grip to be super comfortable. After putting on this Hogue rubber over grip, I now have the grip ergonomics that I've been searching for. It can be a real pain in the butt on install. The company's instructional video shows cutting strips of the plastic packaging part to use as shims and I found myself getting scratched up in the process. I gave up on that process and just warmed up the grip with a hair dryer, it made it more pliable and along with some elbow grease, I got it on.

Fits great! And feels quality. Definitely helps with recoil control when shooting with a firm grip.

It's a little difficult to install but if you follow direction it makes it a little easier. My plastic pice I cut out slid to towards the tip and had to roll the top of grip back to pull them out with pliers . Once on its a good fit and feels decent on the hand. Does make it feel thicker if you have small hand it could cause your finger not to hit the trigger right

The as said this would fit a Sig P320. When it arrived, the package said a P320 FULL SIZE (see 5th pic). That was concerning, since mine is a compact, but there was no need for concern. The directions say to cut two 1” wide shoe horn shapes out of width of the plastic package, but make them from the length so they’ll be long enough (1st pic). Combine that with some Windex-type window cleaner, and the install is fairly simple. First I tried just some window cleaner and only got it about 1/2 way on, then had to struggle to get it off to start over.You know how much a shoe horn helps with a stubborn shoe; this is 2 shoe horns. Make sure you have the horns set so they will stick out at the bottom. The grip then slid into the sleeve without much effort. Then do a fairly light pull with a pliers, and horns came right out.The fit? Great! The grip of the P320 compact is about 1/3 inch shorter that the full size, but, there was NO overhang at the bottom (2nd pic).I did have to trim a little from around both sides of the magazine release (3rd & 4th pix), very necessary for obvious reasons. That coincides with the compact having a slightly shorter grip. I used a small scissors so as not to scratch the grip. Now there are 3 ‘handy’ finger grooves that did not come from the factory.Nice product, I recommend it. The directions do warn that the install can be a pain, but the window cleaner + the 2 shoe horns made it quite doable.

absorbs alot of recoil on my 4 inch 10mm

Exelent grip