49-22-4146 Circular Saw Rip Fence Guide Kit Replaces 6405-6, 6390-20, 6390-21, 6394-21, 6460 Skateplate Circular Saw Guide

Milwaukee 20 volt it fits right in nicely but it does angle down forward pointing 3% or ? Doesn't interfere and works great.The Bauer 20 volt it would fit better but the saw isn't rigid & installing it in the plate is tricky because the plates are cheap but onces it is installed it becomes an improvement to the saw.

Heavy duty and works well.

Works just as it should.

Fits perfectly on my z milwaukee saw

This rip fence guide seems to be well built, with a nice, long slide bracket. Unfortunately, I didn't get a chance to use it as it didn't fit my Ryobi P505 circular saw due to the attachment rod being just a little too thick. The rod is about 11.5mm wide and 3mm thick, while the slot on the saw is 2mm thick.

I had to cut down some 1" X 6" X 10' pressure treated boards lengthwise down the middle. This guide worked perfectly with my circular saw and made the cut clean and easy. This saved me having to use my big old table saw in the basement and getting sawdust everywhere. I was able to do the job outside where it didn't matter where the sawdust went. My saw already had the spring loaded thumb nut on it, so I can't speak about the nuts that are provided, but they look fine if I had to use them..

Used once and it broke

Bought this to use on my new Ryobi cordless 6-1/2" PSBCS01 saw. Ryobi doesn't carry their listed spare part and the other Ryobi alternative parts have size issues. 0.47 inch wide bar is what you want, confirm the item listing specs.None of the provided screws fit the hole, I found some spare that worked so anticipate that. If you tighten it down hard, there's still a little bit of movement. Tighten real hard keeps it from moving but maybe uneven pressure applied over time. I would look into something like thin polyethylene tap over the top and maybe bottom, durable and should be thin enough to shim that little bit of give. Paint or fill in the numbers first in a bright visible color.Everything looked straight, it's essentially one piece. Finish is ok and no sharp edges, could be nicer but it's a small accessory, no need to be so fancy.