🔧 Glue it, don't screw it! The future of soldering is here.
Electrically Conductive Wire Glue is a revolutionary solution for quick and easy electrical connections. This 0.3 oz jar of wire glue allows you to bond low voltage AC and DC circuits without the need for traditional soldering tools, making it ideal for both indoor and outdoor use. Curing overnight, it offers a permanent bond and is user-friendly, allowing for precise application with a simple toothpick.
J**N
works like it is supposed to, give it a try
I read the other comments on how to best use this, worked like a charm. Fixed my dodgy wiring connections on my sprinkler time, 1st try. Recommend.
W**N
Recommended
Good stuff! Works great, follow the instructions and you won't have any problems.
E**Z
Garbage!
Does not conduce. Followed directions. Mixed well. Let cure. Put a meter to the tip of the 4-day-dried mixing stick... nothing. No connectivity not even to itself!!! A complete waste of money.
A**R
Not good for repairing circuit boards
Did not seem to stick like it should. But did coat wire
G**.
It wasn't very fluid
Had to mix it a lot. Not sure if it was working properly since it didn't conduct electricity. I will clean up my job and try again.
J**P
Worked great on low voltage outdoor lighting.
I have a group of 6, 12V outdoor lighting group of lights that enhance our front gardens around our house. On one of the light connections, one of the two wires pulled out of the plastic housing (the electrical connection was down a small hole in the plastic housing. The wire had just pulled out exposing the metal strands of wire. When I pushed the wire back into the hole, the light lit up again, but the wire would not stay inside of the hole. I knew it needed to be soldered....somehow, but with no exposure to the connecting point inside of the plastic housing it was impossible. After a bit of googling and YouTubing, I found this product which was highly recommended. I searched on Amazon, found it, ordered it, it came quickly. I put some of the wire glue on the wires and dropped a bunch down the hole, jammed the wire into the hole (the light came on), I held the wires in place for a few minutes, and after a few months of various weather (warm, wet, cold, etc) the light still works. Great product!
P**N
Not sure what to think
Product and customer descriptions state this product needs to be mixed thoroughly. I'm not so sure. I stirred it with toothpicks till it seemed homogeneous. I super glued a 10k ohm resistor across a plastic piece and applied this product to each end to complete a connection to brass objects on either end. The glue is easy to apply and adheres well to the brass. I allowed it to dry for several days, checking the resistance across the connection. Day 1 netted 18k ohm resistance, day 2 - about 14k ohms with day 3 staying about 14k ohms. However, I am in the US, in Florida, 60% humidity in an air conditioned room. I put the parts in an oven at 150F for about 10 minutes and got to 12k ohms. I figured that was good and, from reading other reviews, decided I'd coat it with fingernail polish. Don't do that. The resistance went to 100k ohms. The polish destroyed something. Attempt 2 - I decided to really mix it so, I took a hobby paint stirrer, the small battery operated kind, and got a really smooth consistency. After applying it as described before, connecting a 10k ohm resistor, the lowest I've gotten so far is 64k ohms. I put it along a toothpick, nothing else, should be like a piece of wire, let it dry for several days and get 28k ohms so, my conclusion is don't mix it, manually stir it. If you can live with 2k - 4k ohms resistance then this is for you. I'm going to let it settle back out, like it was when I received it and maybe try again but, I can't build a circuit with it.
D**H
works
works great.
