TIMBERTECH® Remote Controller for Sliding Gate Motor Kit - 30m Range, 5-Channel Control, One Button Key Fob - Key Chain Ring Pendant Slide Car Gate Operator Automatic Door Opener Motorisation

Very good and work s well a bit expensive

Before I add the instructions on how to pair these remotes to the gate drive, let me just give a quick overview of the remote. These have FINALLY been released in the UK direct from Timbertech after years of them being out of stock everywhere, including Jago.24...the German company that we purchased the Timbertech STAN01 Sliding Gate Operator Kit from originally many years ago. These are expensive by comparison to other 3rd party learning remotes/fobs that look identical to these that are sold everywhere, but those other remotes won't seem to pair with the Timbertech STAN01 sliding gate.Thus, you're forced to purchase these unfortunately. The plus side, is that now we can have them delivered for free with Amazon Prime instead of having to pay the extortionate shipping fees from Germany that we had to previously.There are also NO INSTRUCTIONS packaged with these, which is a major oversight, especially considering the price. I'm only giving 4 stars out of 5 due to both the pricing and the lack of instructions, otherwise these do work as promised.INSTRUCTIONS: HOW TO PAIR (PHOTO INCLUDED)Unlock the black cover on the front bottom of the Motor Drive Unit with the key and open it. Remove the screw at the bottom middle on the right side of the big main grey cover housing the unit and slide off the whole cover.To the left of the main motor, you will see a rectangular grey cover with four screws (one in each corner). Remove these screws, then remove the grey cover. You will now see the circuit board.As shown in the attached photo, there is a small black button labelled AN1 on the left side of the circuit board . Press this button in once and a red LED will light up just above the button. Now press any button on the learning remote you wish to pair with the gate, and this red LED will turn off.Now, and most importantly, YOU NEED TO PRESS THE SAME BUTTON AGAIN ON THE LEARNING REMOTE that you want to use, and the red LED will now blink on and off for about 3 seconds and will then go out.HURRAH!! Your remote is now paired. You can now go and grab yourself a beer/glass of vino/cocktail/valium and get on with your life.

Rubbish, complete waste of money, no instructions how to pair. I have asked for instructions but none can be provided.