DOWELLDOWELL Micro Cutter Flush Cutter Soft Wire Cutters Professional Cutting Copper And Aluminum Wire Cables

These are some of the best flush cutters that I have used. I do a fair amount of modeling and these cutters have blades the line up perfectly and are flat and flush and they remain so. Remember that these are NOT for cutting hard wire and metal they are for cutting softer materials where the accuracy of the cut is what is important. The better the cut, the sanding and finishing you have to do at the site of the cut. That saves time and eliminates the grunt work. Comfortable in the hand and nicely sprung. Highly recommended. Would buy again.

This is actually the second pair of the same snippers I have bought here! Not because they were broken or didn’t perform, actually the exact opposite! They work so well and are so comfortable, I had to buy a second pair for my other electronics kit!Very well built and feel very sturdy, although I haven’t had to put a lot of strain on them. They just fit the hand well, sharp enough to cut and string enough to hold the edge.One of the main issues I find with wire cutters that are meant to cut flush to a flat surface, is they never seems to get the blades aligned to where the underside that sits against the flat surface…flat. One side always seems thinner than the other, and you wind up with sloppy cuts.The first set I bought were almost perfectly crafted to be flush, and required very little adjustment. I actually wouldn’t have needed to adjust them and they would have been fine! I’m just very picky and ocd about this type of thing! lolThe second set needed no adjustment at all! They were so close to being perfectly flush that you would never know, or need to know, that they were off. Because they weren’t!Anyway, great snippers and highly recommended!OH!! lolI play guitar as well, and I use clippers like these when changing strings. 9 out of 10 times, the nickel strings would cut grooves into the clippers when trimming the excess! I haven’t had problem one with these and they don’t show any signs of the strings cutting grooves into the edge. And I’ve cut around 70 strings with the first set! They’re very tough!

Excellent & exactly what was needed, a thin point nipper.

I purchased these as I needed something quick and good quality. They are sharp enough to cut through a fair bit of soldering and wire, are ground so the cut is flat, and overall perform well. They aren't the hardest steel, so I don't expect them to be sharp forever, and they leave the solder a little sharp around the edges, but for the price of these cutters, I think they are exactly what I was looking for, and have nothing big to complain about.

Very happy with these side cutters. They cut close and precise. I am happy with this purchase and would buy again.

This is a nice little tool. Definitely met my expectations!

Value for the price! Good mid level tools !

Nice for the price