ZENY Adjustable Drafting Table with Stool, Tilting Drawing Desk Artist Table with Storage Drawers, Art Craft Workstation for Home Office Reading, Writing, Crafting (Brown-with Outlet)

This art table was just what I was looking for. High quality, easy assembly, I am 69 years old and I put it together myself with no help. All the parts were there, the instructions were very clear. The only issue I had was the packaging was damaged upon delivery but the product was in tact

This table/desk was very easy to assemble. I like that the height of the table is easily adjustable (by one person) by loosening the two knobs on the sides, then raising or lowering the entire top (including drawers). The good part is that when the knobs are loose, you do not have to support the weight of the table top; the top will stay put as you raise/lower it... so you can get it exactly where you want, then lock it in by tightening the screws. I find reviews are most valuable by pointing out the negatives, so here goes.... 1. The feet are cheap. While the feet are nice and big, and are easily adjustable, the plastic is rigid with sharp(ish) edges to all the molded surfaces at the bottom. I think they would scratch a lot of different types of flooring (vinyl, laminate, hardwood, etc). That said, I think putting some thick felt or something under the feet would eliminate that issue. 2. After putting the table together, I had two small screws leftover. They were not mentioned anywhere in the instructions. I knew it was no accident on my part, and, quickly discovered where they belong. They belong on the front and rear edges of the sliding side table. That side table slides between two metal holders. Each holder has an obvious slot. The screws go through each slot and into the table side to prevent it from being pulled all the way out (when extended) or crashing into the table top angle mechanism (when pushed all the way in). However, the table top does not have the holes to install the screws. I quickly drilled the two holes (as this type of MDF board may just crumble if not pre-drilled), then installed the screws. Mystery solved! And, the side table is now safe for me or my kids to use without worrying about it. 3. There is one VERY VERY small defect on my table top. Some kind of debris is between the MDF board and the laminate veneer, causing a tiny, little "pimple". It is on the lower-left of the table top. While it's barely visible, it's enough to redirect a pen/pencil stroke, if under a sheet of paper. Hopefully it's far enough to the left that it will never cause an issue. However, as that is the ONLY defect of that kind on any of the table top, bottom, or side surfaces of the main table or pull-out table, I would think this type of defect is rare and I just happened to get it. Overall, I would give this product a 4.5 star rating... so, I just rounded up.

I absolutely love the table. I would recommend a little more graphic detail to assembling instructions and a little more padding to the stool seat.

The customer service is really professional and this drafting table is well worth the cost. It’s well built and I love it. I’m very happy with my purchase

Relatively easy to assemble, but it does take a while with all the parts. It needed two pairs of hands at different points, so just be aware of that. Otherwise, functionally, this desk is pretty ideal. There's a lip on the edge of the desk which can be positioned up or down, to prevent pens or brushes from rolling to their doom off of the edge of the table. Or, it can be lowered if the desk is laid flat and you have your wrists on the edge of the desk. There is a slideable side-board that can be pushed in if it isn't needed, extending the desk by another 15 or so inches. Storage on the right side is a pivoting wire mesh cup and a number of plastic cutouts for pretty much any hobby. Two drawers underneath add more storage space for flat items (paper, templates, miniature bases or glue tubes). All in all, while this won't win any awards for the best-built desk from quality materials - the design itself is solid, compact and really utilitarian and I couldn't quite find a craft desk which basically supports the five hobbies I am into currently and manages the resources for each in one desk.

I think this table is perfect for my beginning start in watercolor and colored pencil drawing! Assembly was not difficult but directions could benefit from some "top/bottom", "left/right" directions on some steps. I referred back to the Amazon "finished" photo on occasion for help in those cases. My primary challenge was solo assembly as well as my age (68) and getting tired bending/contorting etc. I had no time frame so I did a step or two and then took a break for my back! So overall, it was an all day project but actual time I think 1.5-2 hours. I recently assembled a 150 plus pound Uplift desk which taught me a few ways to deal with the final steps of top into base. The table fits my space perfectly and the drawers allow me to store my most used supplies so I can start painting/drawing without much fuss - YEA. Oh ... I did NOT assemble the stool as I don't need it. Donated to thrift store :)

Got this for our 8 year old. I was worried it might be too high/tall or big, but it’s perfect. He sits and draws for hours. The table is adjustable so is actually the percent height. I saw from the reviews that the drawers were a mesh material so I’m glad I read that beforehand for the warning. They work pretty good for what it is. It’s got a lot of cool little compartments and the little pull out side table thing. It’s a great deal for what you get. I used to have a drafting table for drawing as an adult and it was literally just the table stand with a white top, basic. That’s it. So for this to basically be that with all the other stuff going on AND a chair, it’s a great deal. I probably paid the same amount for just the table alone without all the bells and whistles. It’s an awesome deal and a sturdy piece. I’d recommend it to any artist that needs a drawing space or for an older kid that has a drawing talent that can continue to use it as he/he grows older. Just move the notches up.

this table is just straight up cheap quality and VERY OVERPRICED for what it offers with such quality, some screws dont even work with each other and the tools they provide for you to build it aren't enough and the screw knob hole broke on me and now it's just unusable. I don't usually give reviews to items i bought but this is trash and i just had to give it the review. just buy a desk from a local shop instead of amazon.

Amplio y funcional, facil de armar.

Purchased the desk for my wife's birthday. It was easy to assemble and well made. She loves it. Only issue was delivery. Box looked like it had been thrown down a flight of stairs over and over again. One minor dent and small scratch. Amazed that was all the damage when looking at the condition of the box.

Llegó golpeado y mal empacado

I personally like the table. The stool on the other hand, is crap as it wobbles - I got myself an actual chair.