Breckwell 1 RPM Clockwise Auger Feed Motor, Gearbox Assembly for Pellet stoves, Sealed Ball Bearing with Hole CE-017

Extremely loud till I pulled it apart to grease the gears. Now it works great so far

IT FIXED IT!

Good ager motor and gear box.

This product was as described, was shipped quickly and was packaged well. Installation was quick and easy.

Pellet stove to heat my garage works great easy to install thank you

Installed this as a preventative step because my stove auger motor was original and 15 years old .I figured I'd replace it before it went up but this motor lasted 3 weeks and was considerably louder . I am returning it will just put old one on and keep replacement as a spare because it was only 50$ .The OEM motor is like 200$ I may just buy that as it lasted so long.I do not depend on my stove as a primary source of heat but if you do be careful with this

This motor gearbox fit are pellet stove good . Had to change one wire end ( they had two extra ends in box ) male female female male. Serial number Wh-98-23435 don’t forget to buy new shear clip sold separately if yours is damaged

Motor assembly is NOT an exact fit for the Breckwell P24. The hole in the hardened steel shaft is smaller than the stock assembly which will require a trip to the hardware store for a smaller retaining pin (which will fit in the motor shaft, but be loose in the auger sleeve) or a drill press, vise and a supply of hi speed steel bits. While you're at the hardware store be sure to buy new insulated wire connectors because the connectors on this assembly come with round corners and Breckwell uses square cornered connectors.