Guitar Cavity Shielding Ground Lug with Screw and Ground Wire

Some folks ‘seem’ to give no thought at all towards grounding their guitar circuits. For the life of me I can’t figure out how they can get away with it, because even with the MOST careful circuit I can construct, if I don’t ground everything cleanly & solidly - the noise is inescapable.This makes I think my 7th or 8th build using this Axegrinderz shielding/ground kit. There are alternatives out there. However there’s a lot of outright junk out there too. For the price as well as my positive experience with these, I’ll never use anything different. Perhaps I might build my own if need be but I’ll never buy someone else’s ‘kit’.Simple parts: a length of fairly nice quality 22ga insulated ground wire, a standard two-hole solder lug & screw. It actually IS the “generic equivalent” & therefore it’s in the parts list documentation for many Fender MiM guitars.If I’m honest, it’s pretty straightforward to install, and unless you’re just not paying any attention to what it is that you’re doing, it’s pretty difficult to screw this up.

Easy to use, solder one end to back of potentiometer and attach screw to a pre-shielded pickup cavity. This method has been working great to minimize some of the 60 cycle hum inherent with the Single coil pickups.

Exactly what I needed

Good enough. Too pricey for what it is

Perfect for what I needed

Ground Lug very useful for fasteners application. Well-made quality wire for bass/guitar grounding..

Used to ground my strat after shielding. Worked great.

Generic