Peel and Stick Baseboard Trim,2.1 Inch x 20 Feet Rubber Wall Base Moulding Trim,White Cove Base Vinyl Baseboard (White)

Got this to go around wall and behind toilet wall. Product was just as seller said . It worked great and looked great ! If you don’t need a lot of baseboard this is perfect . And you can just wipe it off with rag . I would recommend this item

Just as described. I used it along the wall on my kitchen countertop. Once applied, it’s stuck. Very good quality.

Best used on flat walls. Not walls with texture. You would need extra adhesive for textured walls

I’ve been needing to replace our tub cove moulding for a couple of years now, but could not locate one that was around 2.5” high and had a nice little kickout slope at the bottom to cover the small gap between the tub face and the tile. I finally found this one and it worked perfectly. It’s very supple and easy to cut with scissors. The adhesive on the back is extremely sticky and adhered to the tub surface without any issues. Once you peel off the backing, be careful with placing it. You’ll be able to shift it only a tiny bit once it’s in place. I started at one end and left the backing in place halfway along the section I needed. I slid the first end into the gap I made in the baseboard that butts up against the tub and aligned the vinyl moulding where I wanted it. Then slowly worked my way towards the other end, adjusting the height as I went and gently pressed it against the tub. Once I had the entire strip mounted, I was able to go back and fine tune it a smidge. Lastly, I used the backing (which is super slick) to rub back and forth a bunch of times to make sure the adhesive was secure. It’s bright white, just like our tub and appears like it will last another 15 years (which is how old the original junky moulding was). For the price at 20’ of product, you can’t go wrong, and will have enough extra if you mess up and cut it too short. To finish the edges off, I recaulked the corners and it looks amazing.

The base trim has strong adhesive which was essential when attaching to old and somewhat dusty floor plate 2x4's. We cleaned the boards as best possible without actually scrubbing them. The trim did what we wanted and held tight enough to create a close seal at the bottom and direct any water away from the wood. Overall we are really happy with the result.

Used the Cove Base where the Bathtub front meets the floor. Covered the gaps, nice and shiny. Most importantly stuck to the metal tub. With other bases, the adhesive would fail and I would have to use other adhesives to make them adhere.

The tape stuck to the wall better than what I was expecting. I made sure to clean the walls before adhering the product. I used a plastic 1 1/2'' putty knife to evenly press against the wall. It's been up for 2 months in the basement and no problems. Things to be aware of: The ends are not cut at perfect 90 degree angles. Sometimes when peeling the red back off it would start pulling the adhesive strip away from the floor base.

Easy to install…very strong adhesive …