eXtremeRateTop Bottom Decorative Trim Shell Compatible with ps5 Edge Controller DIY Replacement Front Back Clip Shell, Custom Black Plates Cover Compatible with ps5 Edge Controller

Awesome product easy installation only took a few minutes to install on the PS5 edge controller everything fit perfect !!!!! Like OEM . Anybody can do this it’s super simple so don’t be intimidated by it . Reason I replaced it was because you see the piece sitting there on the blanket. The rubber was starting to come apart from the controller and bubble.

This was a perfect fit! Easy to install and extremely happy with the product. The original grips on the edge were comfortable but would fall apart with time (poor design IMO). This replacement perfectly solves the problem by removing the grip and feeling completely OEM.

Probably my favorite of the front and backplate replacement of the Dualsense Edge. Served its purpose for a good couple of months, but because of the natural oils and heat from human hands, it can wear down the protective sealant that is protecting the paintjob of the plate. Started showing cracks of that layer where your middle/ring/pinky finger naturally rests on the grip of the controller.

The rubber grip on my Sony Dual Sense Elite controller had been coming off for a while and debated on just pulling it off and living with it. Until I found this replacement. Install was super easy watching the video in the instructions. It doesn't have the rubber grip texture like the original, but that wasn't necessary.If you have a dual sense edge that the rubber grip is peeling off...Go ahead and replace it with this!

Fits perfectly and looks cool. Does it feel as good as the original rubber grips? No, not really. Does it feel just like the base PS5 controller you get with the console? Yes. It’s fine.I was pretty annoyed at the rubber grips peeling off but this is an easy and cheap solution. The shell will fit flush if you follow the directions for putting the new one on. The old one is a real pain to get off. You just have to keep at it and don’t try to force it. Also take the sticks off before you do this. You’ll be laying the controller down and inevitably it will be trying to turn on but it won’t if the sticks are off. Do it on a soft surface. I used the neoprene mat on our gaming table.

Back Panel has enough of a gap to pry it open with your nails.One side of the front panel (left side when you are looking at it) doesn't fit properly, is raised slightly and makes noise when pushed against it.

Purchased this like many others because the grips on the dual edge controller were peeling off. I tried many times to put the back plate on and it never fit. The middle part fit perfectly, but the places it would connect around the grips weren't even close to fitting. I even tried to use a vice grip because I thought maybe I wasn't pushing hard enough. I gave up and put the original back on and it fit perfectly. Maybe I got a poorly made one, but I'm returning it.

Fits just like the original and looks great. Installing was easy. Will definitely be buying the rest of their products for the edge controller.