LeMotech Project Box 5 Pieces ABS Plastic Electrical Project Case Small Junction Box for Electronics White 2.36 x 1.42 x 0.67 inch (60 x 36 x 17 mm)

Just what I needed and fast shipping.

Box's where perfect. Good quality.

I have used these boxes for two projects that use a ESP32-DevKitC-32E Development Board. In one case I have an Ultrasonic Module HC-SR04 Distance Sensor mounted in the box along with the ESP32 board. As can been seen I have cut holes through the box for the ultrasonic transmitter and receivers. The other use is only mounting the ESP32 board inside the box and running wires to a temperature and light sensor through small holes. In both cases I cut a slot for the USB connector to connect directly to the ESP332 board. The lid snaps on tightly, but is not overly difficult to remove.

They are fine but I should have measured b4 I bought these. I needed thicker ones. I just kept them. I had to drill holes on each end to pull cables through each side and make the connection inside the box.

But they work great! My suspended desk slider needed raising juuuuuust a little bit. But not raise up so much my keyboard and mouse get squished. They look nice too, like it's part of the slider. These were a very inexpensive solution to an ergonomic problem. I used four of the five and maybe I can use the fifth as an actual container. Ha!

Not water proof

Used as junction boxes for LED light bars in my barn. I didn't want a big 4" box at 8-10$ a piece. lower profile and lower cost. Worked perfect for what I wanted. Just had to drill the holes.

Mounted USB charging ports in a motorhome using a combination of screws and 3M mounting tape depending on the mounting surface.