Coopache Invisible Ring Size Adjuster 16 Pack 8 Sizes Ring Tightener Guard Reducer for Loose Rings Women Men, Make Ring Smaller Without Resizing, Transparent (RSA05)

I found the adjuster easy to fit. The instructions were pretty clear. After attaching the adjuster to my ring, I trimmed each end, in small increments, until the ring fitted my finger perfectly. At first it felt a bit odd, but after a short while, it feels fine. The adjuster is invisible on the face of the ring and is pretty inconspicuous against the palm of my hand-will definitely use again and I would recommend.

The silicon units were easy to use and reduced the ring by over 2 sizes. BUT I only wish the manufacturer listened to people who have used them and left reviews.Sell the same size in one package. OK they will be a large multiple but when you've used them and know what size you use it would be very helpful to be sold in that size but 10 or 20 of them in a packet!

I liked at how simple they are to use and my rings stay in place. Highly recommend them.

Unfortunately the adjusters didn't fit snuggly enough for me to put the ring on without turning it or putting pressure on the ring until it went over my knuckle.They are very uncomfortable, after cutting the adjuster (following the instructions) to size it would stab my finger.I used 2 from the pack which both snapped.

The idea is good but matching the size is difficult

I used this on a my wedding band that had got so loose it kept slipping off my finger and I was afraid I would lose it.From within the packet of assorted sizes I chose the size that fitted my ring.I followed the fitting instructions and threaded the retaining strap through the slot and pulled it up tight. That’s where I encountered a problem.I pulled the retaining strap through the slot to tighten it against the ring and I run out of retaining ridges. The ridges didn’t go far enough around the strap, so when it was cut to length (it works on the principle of a zip tie) there was nothing to hold it in place.Luckily I got over this by cutting the retaining strap off completely and pushed the U section silicon spacer part onto my ring and slid the ring and spacer onto my finger. It now fits my finger perfectly and because the ring fits inside the spacer U section so it doesn’t slide out from under my ring. Dropped a star for the retaining band issue.Update: Silicon spacer went black after a few weeks of continuous use and began irritating my skin under the ring, had to take it off in the end.One of those things that sounds like a good idea, but doesn’t work out in the end.

Was so easy to do and works brilliantly.

very easy to fit what more could i ask for and at a price and fast delivery