Nad's Eyebrow Shaper Wax Kit Eyebrow Facial Hair Removal Delicate Areas Cotton Strips, Cleansing Wipes, 0.2 Ounce (Pack of 1)

I'm guessing the people who put negative reviews for this just didn't do it right because when you follow the directions it is awesome. I'm going to do a step-by-step here of what worked for me.First step, if the gunk is cold then you need to warm it up. The directions say you can place it in some warm water or rub it between your hands. I stuck it in my bra while I read the directions. Consistency was perfect after about five minutes. I'm pointing this out because I think it's important and could be another cause of the other complaints about the product if the users didn't warm it up first.Next, wash your face with clarifying face wash (I literally used dish soap because I had heavy moisturizer on). Next, use the included towelettes to wipe the area where you will be using the product and dry thoroughly.Also, the directions say to NOT do this right after a shower because something about your skin being too soft or something. Not a problem here. I did not shower before, but just thought I would point that out because that could be another reason it didn't work for other people.After the towelette, thoroughly dry the skin. I used this for my eyebrows only. The directions also say your hairs need to be a certain length for this to work. Again, no problem here because mine were lookin' straight sasquatch - quite long. But, again, could be another reason it didn't work for some people.When you're ready to begin, have a good magnifying mirror, preferably with a light, unless you can see really good up close, which I can't. I bought one here on Amazon when I bought this stuff, and I got some awesome tweezers too. I'll try to find links and post them. The mirror has a USB plug. Perfect. Anyway, I digress.So, take the tube of gunk (now warmed by your body heat) and twist the end several times until you see it start to come out of the tube. This next part is important, apply it to the hairs you want to remove IN THE DIRECTION THE HAIR GROWS, meaning from the roots to the ends.Next, quickly take the little fabric strip and place it over the gunk and rub it 3 to 4 times in one direction, THE DIRECTION THE HAIR GROWS - not back and forth, just one direction from roots to ends sort of smoothing it down into the gunk.Third, grab the strip of fabric with one hand and place your other hand on the skin to hold it taut and quickly rip it off the OPPOSITE direction - meaning, grab the strip at the ends of the hairs, not the root end. You pull AGAINST THE DIRECTION THE HAIR GROWS. This is VERY important and I know could be a reason that it didn't work for other people because I accidentally did this more than once. No hairs came off on the strip when I yanked and then I realized I had yanked from the root end, not the other end and the hair did not come out.If you do it right and yank in the correct direction, like magic, all of your hair will come out and be stuck to the fabric strip. The strips are reusable and the gunk is water soluble and just washes off so if you accidentally get it where you don't want to remove your hair you can just wash it off and start over. You rinse the strips when you're done too and it comes right out. I don't know what this stuff is made out of, but for me it worked perfectly. I couldn't be happier. And way less of a pain in the arse than trying to melt actual wax and have it be the right temperature and all that. No way!If your brows are lookin' squatchy and you don't want to go to the salon, use this stuff.

I'm going to be very honest about this product.I am not new to waxing, I am a hairy person and have to wax every 2 weeks or so, which means I've tried a LOT of waxing products. This one was in fact the worst. The wax formula is weak, and does not adhere to the hair. I followed the instructions to the T my first try, because some products will not perform well otherwise. I then decided to use it the way I normally would, which ended up being a flop as well. I think the worst part about it was I purchased this for convenient travel, but I showed up to a funeral looking crazy. I'm actually a bit shocked that this didn't work well, given the reviews I've seen showing that it worked well. Needless to say it was disappointing and I will likely not purchase any products from this brand again.

Outstanding product! I followed the advice here--heated the tube under hot water, put the cotton strip on and smoothed in the direction of the hair, and pulled the cotton off quickly in the opposite direction of growth. Warming the wax is essential because by the time I got to my second brow, the wax had cooled and didn't apply as well. Once I got the technique down, though💥 WOW. I'll never do my brows any other way and won't pay to have them done. I got exactly the line and shape I want. This wand is magic!

Nad's Body Wax Strips are easy to use and convenient for at-home hair removal. They work well on finer hair, but for coarser hair, multiple passes may be needed, which can cause some irritation. The included post-wax wipes help remove residue, but the wax can still be a bit sticky. Overall, it's a decent product for quick touch-ups, but it may not be the best for thorough hair removal.

This is easy to use and works fairly well. If your hair is long enough to be waxed, it works, but the shorter ones you will need to pluck.

I don't want to say it is all bad, but my tip popped off and gel pushed out of the large opening. Without gel in the tip, it doesn't work. You just cannot get it back together with this mess.

I highly recommend this product. I have limited space to store things and this is small enough to keep in my travel makeup bag. On top of that I don’t have a whole lot of time to myself so doing my eyebrows took me 6 minutes to do was a huge plus. I’m already recommending this to my friends that are also in the same boat as me with limited space and time.

This is definitely not for beginners I guess. I usually wax my own eyebrows and decides to get this for when I was in a rush… there was just no way that I could make this work. I tried 2times before trashing it