Creality Official 3D Printer LED Light Bar Kit Upgrade Led Chip, 24V Rated Voltage For Ender 3 S1 / Ender 3 S1 Pro 3D Printer

Was a bit of a pain to install onto my ender 3 V3 KE, but got there in the end, very bright too.

It is VERY well built and lights up my work area

Fitted to Ender-3 S1 without any issues.If you are looking at this light bar, you probably have a skillset suitable for the installation. The correct method of installing the light bar involves removing the "Z" axis uprights from the base unit to trunk the cables through the extruded aluminium axis nearest to the screen and out of harm's way.Feeding the cables correctly into the light bar switch bracket is quite fiddly and patience will be required. Care must be taken around the sharp ends of the extruded aluminium to ensure the cable insulation is not damaged (and your fingers). I would advise checking there is no strain on the cable where it connects to the available power source on the base, before bolting the uprights fully back into place. My only criticism of the two-piece wiring harness would be that it has too much excess cable between the top of the upright loom and the light bar switch bracket loom, which due to the size of the wiring connector cannot be routed or stored as I would have liked.After some tinkering and fiddling, the reward is impressive. The light from the bar was much better than anticipated, lighting up the whole print bed and more with a cool bright white light.Basic instructions are supplied, and installation videos are online if you are not sure.I shopped around and picked this up for £17.99 in the Amazon Warehouse section, although the light bar is readily available on the regular site.

Perfect fit as you would expect. Very bright and easy to install.Arrived quickly from AmazonTip to hide the wiring is to run it inside the v tube and follow the filament sensor wiring by removing the plastic cover and push it back in when done.

Excellent product everything works as it should my machine is the ender S1.wiring hidden , I am very pleased with the results. Watch the video on Amazon , the instructions are not very well written, there are two plastic squares one in each aluminium vertical extrusion to be removed for fixing screws .

It works well. Obviously you get a shadow from the x axis rail but that’s to be expected. Useful for monitoring prints in the evening or at night without having to light up the whole room.

it was a pain to fit and only worked for 2 mins and now doesn't work at all wouldn't recommend at the price its on right now i would say when it did work for 1 mins it was bright and looked good but wouldn't recommend it for the reason it made me ke not work after 1 min and had to remove light bar for my ke to reboot up again

Fitted straight on with no problems, threaded the cable down the same route as the filament sensor cable. The light is bright with a natural white hue. It is suprisingly stable and stiff once fitted. Very happy with it

Vibra un pò, ma fa il suo dovere, semplice da installare

Passt alles, Helligkeit ok

Ottimo prodotto lo consiglio a tutti fa molta luce e si ha una buona visione della stampa in fase di lavoro.

È semplice montarla, ma ho paura a smontare la stampante 3d per fare il lavoro.non voglio friggere tutto

Il manque les petits « brackets » gauche et droite pour fixer sur l’imprimante… je vais tenter de trouver un fichier stp pour les imprimer… mais au vu du prix et de la qualité du produit, en plus il manque des composants… un peu déçu…