Camera Hot Shoe Mount to 1/4"-20 Tripod Screw Adapter,Flash Shoe Mount for DSLR Camera Rig (Pack of 4)

I purchased these because of their compactness and sturdy aluminum design. They work quite well to secure my flashes onto tripod mounts that I move around constantly. I definitely recommend these to anyone wanting a low footprint non-plastic mount.

I have purchased many of these in the last few months. I do not use them as a "shoe" but they are a great way to mount a camera to anything you are willing to drill. I used them for my rear dash cam (JooVuu X) and on all my shooting headsets to mount my action camera (Contour ROAM3).They are very sturdy and light because they are made of aluminum. I have been putting on and off the camera between all my headsets and I have had no problem with any of them. I found these mounts so useful that I decided to keep a couple extra in my drawer at all times because I am sure I will need them for other cameras and one that comes to mind is my spare Arlo Pro 2 camera.

Most other products convert the other direction from a cold shoe to a male stud. I needed mail stud to cold shoe and these work perfectly. I bought them specifically because they are very small very lightweight and do a great job at holding onto my expensive speed lights.

can hold all kinds of slotted items, recommended

I'm using these for a slightly different purpose than intended. I'm attaching something thin to the 1/4-20 stud on the top of light stand spigots and I needed a "nut" that I could easily hand tighten. These work fine. I wish the serrated edges on the discs were sharper and more grippy, but overall I'm pleased with them and the price. (I've got 8 discs now!) Since I leave these discs on the spigots when the light stands are packed for travel, I've added 20mm x 3mm silicone bumper pad to the top of the disc for a bit of protection. Product arrived on time and in perfect condition. Highly recommended.

Needed an accessory to connect a flash unit to the top of a hiking pole that was already threaded. This little piece worked perfectly and now have an inexpensive way to position a flash unit above my subject.

The threads aren't cut consistently so you end up with some of the nuts badly scoring the threads on the posts or unable to close all the way. I only needed 2 and the kit came with 4 and they're cheap so, I'll get what I need out of them.If you're looking for high-quality, smooth threads, look elsewhere.

Can’t expenses how terrible the quality is. You immediately know they’re cheap because they’re made out of aluminum (my assumption) not sure if that’s because it’s a “hot shoe mount” but iron or bronze would have been a better choice. The paint comes off after the first use, but whatever. The worst part is the fact that the washers have no gripping power for tightening. It’s like trying to screw on a ring of butter. You’re better off buying a quality brand even if it’s $10 for 1 than buying these.