UTMALLUniversal Ribbed Drive Pulley Crankshaft Remover Tool Puller for A/C Unit Water Pumps

I have a Mercury Grand Marquis 2004 4.6 L V8 I use this on my AC pulley to put a new clutch on it had exactly enough clearance at the maximum settings to fit on their perfectly I like how the sides were able to be snugged in perfectly and a socket meant to fit into the main screw it went on smooth and came off smooth too thank you

Muy útil para poleas de polimero y metálicas

This worked really well on A/C compressor pulley even though it is designed more for other ribbed pulleys. It has a large notch that works on the rim of the A/C pulley.Because I had to back off pushing bolt halfway into crossbar it made it harder to align and threads could get damaged, I put a plastic sleave over the compressor shaft that also fit into centre of bar, which got it aligned easily in the cramped work area.When aligned then snug tight one puller bar, take off and tighten down a little more with allen wrench, put back on so it is on top part of pulley and then slide other puller bar up to pulley, and tighten with allen wrench. I was expecting it to not be easy and was amazed at how well it workedIt is heavy solid steel and can remove pulleys that are on tight in small spaces. It is strong enough to damage frozen on pulleys. This a cost bit more than renting a similar tool but is worth having for other uses.

Works pretty good. Can tend to loosen up. Extra caution on aluminum pulleys. Make sure it's firmly seated at the outer pulley flange or it will tear through the grooves. I did that but my fault; not fault of the tool. For occasional use it's good enough without breaking the bank.

Works