The BeadsmithWig Jig, Wig-A-Ma-Jig Beginner kit, includes 3 x 4 inch clear plastic jig, includes plastic pegs and 2 yards of copper, silver and gold craft wire

This is a bit unstable and difficult to use the pegs don’t all fit right so there is some mid shaping that occurs

Arrived quickly, was smaller than expected but still served its purpose. Easy to store inexpensive and works great. Would orde again only full size the second time.

I'm a beginner and for a beginner its good for smaller design work, but pegs and holes sometimes don't match up. Came with 10 small, 2 med, 1 LG peg.....board is pretty sturdy plastic. Again, for beginners it's good for practice. Will definitely make my own larger one later.

Well it lasted a whole 2 min... first time I tried to use it,one of the pegs broke off in the jig when I tried to remove it. I wasn't pulling too hard or at a weird angle, it just broke. The actual jig however is really sturdy. Not the pegs though. Most dont fit properly and are too big to put into the holes. I'm disappointed . I'll have to return it or try to get the company to send more pegs.

This little thing is fine as long as you’re using thin flexible wire. I started trying to use 16 ga copper on it & the pegs immediately snapped in half. I switched to a 20 ga & they seem to be holding up okay.If you’re using this for 29 ga wire or under, this should be fine. For a larger ga or harder wire, invest in one with metal pegs.

The wire and peg board are decent the plastic pegs are very flimsy and break easily! The pegs don't fit and or can't get them outof the board. I have three bent pegs and two broken ones. Today was the first time I used this product and have bent and broken pegs. I had to drill one of the broken pegs, it was the only way to get it out of the board. I suggest buying a wig jig with metal pegs.

I found that the pins come out too easy so it makes it difficult to work with. But it is plastic, so it goes with the price. Wire with it is good way to start. One needs a jewelry hammer to get a good finished product.

About 1/3 of the pins do not fit into the holes. Would be nice to have more pin size options.

Some pegs are too tight and some pegs are too loose slipping out when trying to wind wire around them.

A great tool but the pegs are a bit weak/fragile

I expected this to be flimsy but it is even more so than expected. The pegs don't stay in the holes and have had to apply a bit of pva to each one to get a bit of gumption. I have almost given up on it and handed it over to my 4 year old to play with.

This thing-a-ma jig is such fun to use. I have made different shaped earing and necklaces. I found that the wire youre sent is very good quality

Liked the various sizes of pins