7 Inch Motorcycle Headlight Housing Bracket Headlamp Shell 7" LED Headlight Bucket Mount for Harley Suzuki Chopper Cafe Racer Bobbe Aprilia Matte Black Motorbike Headlight Bucket

Ordered 2 of these bracket/housings. I say 50/50 because 1 of 2 seemed to be used or older hardware that the other. The one that seemed used had silver clips, the rubber grommet it smaller in width, and hard to get both side bolts in. The 2nd had gold clips that were tighter and fit good, rubber grommet fit perfect and was wider, all screws and bolts went in easy. Just weird that got 2 of same thing but they had little differences. Nice product though. Would buy again.

I bought two of these for my two ebikes and installing the headlight was the easy part in my opinion, yes it does not come with instructions, but you use the pins to secure the headlight into the housing (frame) at 4 different points, basically you put one side of the clip in the lip and slide the other end underneath of the lip 12, 3, 6, 9 o'clock positions so it can apply pressure evenly to the headlight, against the headlight housing (frame) thus holding int place. Just YouTube it and you will find videos on how, the only reason I can't give 5 is because one of them came with some scratches up on the outside, and the other one, the screw holes to, "seal" the hosing, on the bottom don't line up so one of my ebike the headlight is not "sealed" evenly across, and one housing is scratched up, But I don't plan on using my ebike in inclement weather so it still meets my needs, and would still recommend to friends if they were looking for a headlight housing for their eBike.

Absolutely trash, the ring that holds the light and clips is to big, it's to deep for led, the clips don't hold anything because once you get it together the light just falls back into the bucket. Very upset because I'm missing out on a big ride this weekend without a headlight.

Its a great bucket. Perfect fitting for aftermarket lights, although I did have to cut the rear wire hole larger in order to get all of my plugs to fit. I had to reference the review pictures in order to figure out how to use the clips because there were NO installation instructions.Once I did get them on everything else was a breeze. Great product but be sure to come back and look at others pictures and advice on how to make it easy on yourself.

The clips to hold the headlight in place are simple enough, but they are confounding to figure out. I wish the bucket of the headlight were deeper to provide a space to hide wiring behind the headlight itself. Otherwise, it's fine. Just fine.

Did a front end swap on my bike and needed a lower profile bucket for the headlight. I came across this because it had the matte effect I wanted and seemed to be pretty solid. There are only two small complaints I have. The two screw supplies aren’t coated well so they started to rust after a single bike wash. No biggie. The tabs that are used to thread into are a little off, so had to tweak those a bit to get the bucket shut. Other than the mounting brackets to the forks being garbage and shouldn’t be used, the bucket is really nice and I’m pleased with it.

Buena calidad

Had trouble figuring out the clips but a video here by Tyler set me straight. It fit together perfectly with LED I had ordered separately from Skunksomething.