Share Goo Aluminum Wheel Hubs 17mm Hex Nuts Threadlock Compatible with Traxxas E-Revo E-Maxx Revo 3.3 Slayer Pro 4x4 Summit XO-1 1/10 Off-Road Climbing Car (Black)

Had the first set stolen off my porch... Informed amazon of this and they were kind enough to send me another set... They work perfectly , excellent fit...

They look great, but the bores are machined too large and will cause the wheels to have excessive play/wobble.The original used Traxxas hubs I removed fit tight and have no play.

They work as they should and the price was great

I was able to get this to work for Arrma 3s Senton by using it with the end bolts from this: https://www.amazon.com/dp/B073ZBDRTH/ref=cm_sw_r_cp_apa_fabc_HA5Y6RPG7HX6G8A89FVNWithout the bolts, this kit eventually shakes loose and causes wheel wobble no matter how much locktite you use or how tight you tighten everything down. It should just come with the end bolts as part of the kit.

The pins are very very cheaply made and broke both of the rears on my brushless E-Revo within 5 minutes of installation not sure what they're made out of but it is nowhere near strong enough to hold the power.other than that the adapters themselves have held up after a pretty hard day of bashing after I replace the screw pins with some hardened steel ones that I had

Fit great on my Typhon 3s

I installed these on my Traxxas T-maxx 2.5 with a brushless conversion. The pen that goes through the part is threaded but it loosens within about 5 minutes of driving, this causes I noticeable amount of play in each wheel.

Just got around to installing my new 17mm lugs and new wheels on my 14year old nitro Revo. Installed 3 of them than realized only 3 were in the pack. I have 4 pins but 3 adapters and lugs.