RC Model Hop-ups 12mm Hex Wheel Hubs(4) 7mm Thick for Traxxas 1/10 4WD Rustler,Slash,Stampede-Replaces Part 1654(4pcs)

These hexs work great, though I did have a minor fitment issue on the front of my 2wd Slash. The slot for the stub axle is deeper than the original plastic hexes, which meant that when I tightened my wheel nuts, the back of the hex was wedged against the bearings, causing major binding. A few minutes and some sandpaper took off enough material to stop that. These are advertised for the 4wd Traxxas products, so that's likely where my issue came from. Still, easily solved, and only a few minutes of time.

No issue with my slash. I bought the version for my 2wd rustler though and those didn't work quite as good,

The media could not be loaded.  came in 2 days. a day faster then quoted! and there exactly what was described

nice fitment, looks great and good value

I bought a set of these after I rounded out one of the plastic ones that came with my Slash. They looked good and fit perfectly. I have had no further issues and as so impressed that I ordered another set for my son's 4x4 Rustler.

Coda Racing is up there with competing with Traxxas products. Ive bought 4 or 5 products from Coda and have had NO ISSUES. There well built and fit perfect.

These work better than the Traxxas hexes, since they have set screws to lock them in place. The cross pins no longer fall out when removing tires. Getting them just tight enough without binding the front wheel bearings is a bit difficult, but just takes a little trial and error. They are nicely machined and wheels fit evenly and tightly.