Dorman 57000 Plug Retainer Compatible with Select Cadillac / Chevrolet / GMC Models

Oem fitment

This was a perfect fit and super easy to install. Do yourself a favor and YouTube the hack on how to install. Took me under 5 minutes to complete and they work great now. Different from original, so I did have to replace both of them in my Yukon. They snap tight and look great!

1-* from J Bridges on July 3, 2022 Great replacement item, would be easy to install if postal service had not have lost ! This item was ordered on June 26 to be delivered on June 28, 2022. Have not received as of July 3, 2022 by USPS. The item was shipped to USPS Greensboro NC, 28 miles from my residence , then reshipped to a USPS Garner NC over 75 miles away & they cannot locate even...

Perfect snug fit. I’d rate it a 5 if they didn’t have to be put in with the lids folding opposite of the way they normally would. The tabs have no choice, but work wonderfully

Perfect fit! Super Fast Shipping too! For those who don't know how to remove the old ones and install these, it's easy. Take off small panel between driver doors door left side of dash, remove 2 screws under steering wheel column, remove bolt that holds parking brake lever, pull "outward" the lower panel under steering column, remove the folding tray on lower panel under center console, remove 2 screws from in there, remove 2 small bolts on left side of that lower center panel, then pull outward starting at bottom left corner and work your way either way. Once it's off, you just pry out the upper center panel that goes around stereo/thermostat controls. Then you will have access the all harnesses behind it. Just unplug the harness for whichever one or both of the 12v accessory outlets, use a small pick/screwdriver to push in the retainer "inside" the outlet, and push "OUTWARD" and the actual outlet will come outwards. It may be tight, but just push then pull the rest of the way out. Once the outlet is out, the retainer cover will easily come out. Repeat these steps in reverse to reassemble everything. Put new retainer in first, the push in the outlet, then plug harness/harnesses back in, and keep going. Remember to pull outward on the panels, NOT down, NOT just one corner..... try to pull outward EVENLY or you can break the retainer clips that secure the panels. Sucks if it does. I hope this helps.

Ordered matching plug. Cover would not close. Wound up ordering GM parts for less.

Although the installation for these was waaaay more than i figured it would be thats no fault of the provider of this item and the item itself is good enough to not be any different than oem parts. Couldnt justify going and spending any more than the price of these for the function they serve which realistically is just looks. i bought them because the covers on the factory ones are cheap and broke fairly quickly and i just wanted a uniform look on the nice ltz interior of my truck. Something minor but i figured its worth it. If i unfortunately had to replace these again i would buy again through this seller.

I ordered these to replace the broken caps on my 2009 Silverado. They fit perfectly. Pain in the behind to install but that makes it a tight fit. Caps snap on and off as they should. I used needle nose plyers to wiggle out the old and snap the clips on the old ones as well. Takes a lot of effort to slide the new piece on but it fits snug. Why do we need to replace the old ones that snapped? OCD. Ugh.

Perfect

Encajan perfectamente y muy fácil de instalar

ممتاز

Work and look great. Actually look better and seem better quality than the flimsy factory ones.

Did not match the original factory part but does look good. Very easy to install