LLPT Aluminum Foil Tape 2 Inches x 65 Feet 3.94 Mil High Temp Heavy Duty Adhesive HVAC Sealing Hot Cold Air Duct Tape for Pipe Metal Repair (A2065)

Works great

I needed a reflective surface on a wall to reflect back the indicator lights of a wrong-facing disk drive enclosure. This tape does the job and doesn't seem likely to fall off the wall.The edge of the tape isn't quite as shown in the picture - it's slightly raised (bent) for maybe 1/8 inch on each edge, as if the knives that slice the tape into 2-inch widths were not sharp enough. But it would work just fine for its intended purpose, so I'm not marking it down for that.

I'm using this to patch a hole in my muffler, so far it's working pretty well

I was skeptical about making this purchased because of some of the reviews. I am glad that I decided to purchase this item to use on my dryer hose. It was very easy for me to apply with no problems what so ever! I decided to cut the tape in shorter pieces in stead of long pieces. That may be why it was so simple for me to apply. Not too sure why others had such difficulties with the adhesive or it being difficult to use. For me, I did not have any waste of product. This is my honest opinion and I would definitely purchase again if I ever run out. However, I don't forsee that happening. It was more than I needed. However, when it comes time for me to clean my dryer hose, I have it on hand to remove the old tape and replace it with new tape. I wish that I knew of this tape along time ago! It would have saved me a lot of headaches and the dreadful pain staking time it took me to get my dryer hose to stay connected to my current and past dryers as well as the dryer vents.

The media could not be loaded. I put it on my A/C pipe and the window to hold the plexiglass in place. as u can see in video it's coming down rain .I'm in Washington lol we're the evergreen state.lol ..I hope it holds up to the heat ,whenever tht is lol

I used this to seal up A/C & humidifier vents. It has a great thickness that seals up effectively but can still be easily shaped. The adhesion was great and has not had any issues. Would purchase again.

It is sticky - the backing was a pain to remove until we discovered to flick the corner from the metal side and then pull the backing awayMy husband used it to make a bicycle wheel wind spinner. It is bright and reflects the light nicely. We'll see how long the metal tape lasts in our winds.

We did not like it, it did not stick.