🎤 Elevate Your Audio Game!
The Wee2POND Replacement Horn Diaphragm is a high-quality, cost-effective alternative for JBL 2414H series drivers. With a 1" voice coil and 8 ohm impedance, this diaphragm is designed for universal fit and delivers exceptional sound clarity. Made with a durable Mylar dome and copper voice coil on a Kapton former, it ensures longevity and low noise operation, making it an ideal choice for enhancing your PA system or high-frequency compression drivers.
Style Name | Modern |
Noise Level | 8 dB |
Fit Type | Universal Fit |
Voltage | 12 Volts |
Material Type | Copper |
E**G
Works well.
Well made copy.I can't hear the difference between the original and this one.Good value
M**Y
Good sound
It gives a good sound. I use it as a mobile DJ.
O**
Worked fine.
Was easy fitted.
J**N
Failed Immediately
I have 4 PRX415's flown from the ceiling in a banquet hall, each side has two. Each side is driven from a crown xti2000 in bridged mono mode. I have had this installation set up this way since 2014. I had three compression drivers damaged by a band, but only had one factory JBL compression driver on hand as a replacement. I put both remaining good drivers, one that survived, and one new in box JBL replacement on the outside two speakers of the groups. I then replaced the two remaining middle speakers with these compression drivers as I was able to get them shipped faster than the factory JBL drivers. Upon doing a sine-wave sweep at approximately 1/8th power both of these aftermarket drivers failed, but both factory JBL drivers were fine. I thought maybe I got two bad diaphragms, and I had ordered 3, so I replaced one of them with the remaining Wee2POND diaphragm, It also failed instantly when I performed the sine-wave sweep to RTA the room with the new diaphragms.All three of the Wee2POND diaphragms appeared to have a very low output at approximately 8.2khz which returned around 9khz and then the diaphragms all failed at around 10khz during a fast sine-wave sweep at 1/8th power.I have since replaced the remaining two broken compression drivers with factory JBL drivers, and was able to perform a sine-wave sweep and RTA the room multiple times without driver failure.These drivers appear to be poorly constructed and I would advise to stay away, unless you either run them at incredibly low power levels, or don't mind replacing them every 5 minutes.
T**Y
Great Replacement for my JBL EON 510
Great product, cheaper than OEM would buy another one again.
L**W
Gave it an operationalctesting of a weekend festival and it held up so must be good
Held up as required. A weekend festival pushing it to limits and worked fine .
A**O
Muy bueno
Llego bien y funciona perfectamente
J**
Excelente
Super
TrustPilot
1天前
2 个月前