4Pcs Hairpin Table Legs Heavy Duty DIY Furniture Metal Table Legs with Free Screws & Protector Feet - Stable Standard Table Height, 10cm to 72cm, 2Rods, Raw Steel (20cm)

I built a tabletop from scaffolding boards and used these as the legs.They work OK but are not brilliantly sturdy.I have the desk built into an alcove so there isn't too much movement, but it that wasn't the case I think thetable would move around too much.The screws provided are poor quality and several stripped the heads trying to tighten, so would suggest using alternative screws.

Just wanted to complain about the screw that are supplied with the legs ,, they are really low quality and didn’t really do the job ,, they wouldn’t survive coming in and out of the legs ,, I had to buy some more screws to replace,, but the legs are good

I bought these for a chest of drawers that I was up cycling. I spray painted them gold which stuck very well.The legs are really sturdy and amazing quality for the price I paid. Comes with little floor protectors too which is good for my wood floors.

Bought 2 sets to make side tablets. Good quality and easy to fit

I was amazed at the quality of these legs, just what I was looking for, contemporary & a little industrial looking. Absolutely amazing for the cost, total bargain, thank you!

I wanted to raise a small filing cabinet off the floor & thought metal legs would look good. My only concern was metal legs would damage the floor. But these came with very solid rubber stoppers.Perfect for the Job, sturdy, well made & accurate. All legs built to the same specification meant it sits well in the corner & looks good.I thought I'd baton the base as I couldn't screw into the cabinet due to the drawer, so I just needed to use wood screws not the ones supplied. I'm very pleased.

Bought these to replace legs on a solid teak table top - which has three solid teal drawers and is very very heavy. I was worried they might not be up to the job but they are really sturdy and handle the weight just fine.The only issue was that the holes were not quite 6mm so the m6 screws I had to attach them would not fit. Very easy to fix with a 6mm cobalt drill bit - drilled them all to proper advertised size very quickly.

The legs themselves are very good, exactly the strength and effect I wanted. The screws which came with legs were very poor quality soft metal. Only slight pressure in fixing/tightening destroyed the head so could not even remove easily to replace with appropriate screws