🔧 Build Better, Build Faster!
The MakerBeamCorner Brackets pack includes 12 stainless steel brackets designed specifically for MakerBeam systems. Each bracket measures 32x32x10mm and weighs only 0.3 ounces, providing a lightweight yet strong solution for enhancing your designs. Compatible with both MakerBeam and OpenBeam, these brackets allow for quick assembly and reusability, making them ideal for professional prototyping and electronics projects.
A**R
also not a huge deal since it’s pretty obvious that it’s a right angle
Agree with the other review. Hardware store quality and the holes were slightly offset. Normally wouldn’t be a big deal, but I needed to drill out a hole to 7mm with a stepped bit and nearly broke out one side. May have to resort to narrow washers as cover-up. Also note, there wasn’t any engraving on these; also not a huge deal since it’s pretty obvious that it’s a right angle.
E**R
Quality brackets
I've purchased almost the entire Makerbeam collection and it's all very nicely made. Very versatile and strong.
D**T
Overpriced but works fine, finish left a little to be desired.
Mostly good - they are cut perfectly to the width of the MakerBeam, I found the finish a little mediocre, and tolerance of the holes a little too loose - plus frankly paying that much for 12 pieces of bent metal was not my favorite thing to do - next time I may just cut some aluminum L brackets to 1cm sections and drill my own holes.
B**B
Can't use adjacent T-slot nuts
There are two holes on each face of the bracket. Cannot use both holes on the same face if using T-slot nuts because the holes are spaced 10mm on-center, and the threaded holes of two nuts that touch each other can come no closer than about 15mm on-center.
D**B
Way overpriced.
They fit, but really, the price?
TrustPilot
1 个月前
1 个月前