MOBOREST RCA Cable Audio Adapter, Phono RCA Male Plug to AV Screw Terminal Au...

These plugs worked great. They were easy to setup and worked flawlessly. They arrived on time and in perfect working order.

Perfect for speaker wire!

Worked for me. I broke the tip off of my subwoofer cable which is in a place where it can't be easily swapped. This did the job without me needing to learn soldering. I would have given this 5 stars but there aren't instructions. For anyone else wanting to know, here's what you do. Main/center wire with the signal screws into the positive side. The shield/ground wire(s) screw into the negative side. Wrap with electrical tape when all done.

I used these to easily connect my pos-neg wires to it that feeds into a custom (DIY) speaker setup that I made that takes the RCA to wire y-adapter to the speakers in the enclosure, making an easy and efficient disconnect. I love using these adapters as it allows me to easily plug and unplug them without loosing the polarity of the wires to the speakers and not have any exposed wires. These would also be awesome and clean if you had an amplifier that only took the hi-level inputs via RCA, but still allowing you to easily take out the wires if need be, this is nice because then you don’t have to hard wire a RCA to wire y-adapter. Unnecessary if you plan on a permanent installation, but this is really handy if it isn’t permanent.

Llego muy rapido y conecto perfecto. LO recomiendo

Have to solder when multiple locations say a screw driver only is needed. Under further investigation there is one location that states soldering required… mess of description for this product.

Buen Articulo,Excelente Vendedor, Gracias

Exactly as advertised

Buenos materiales, fácil de manejar

Very good replacement for logitech z407 speaker cable rca, instead of welding thing that is impossible for me to be done

I decided on these. Made the right choice. you basically have one chance to solder them well. Even if you apply too much heat you can still make them work. What you do is take coaxial able and put the center conductor in the center slot on these. Then apply a decent amount of heat and rosin core solder. Then take the negative fold it back and crimp with the tabs. Very good quality the grommet on the back will fit the cable you may have to cut it back a little to fit. Highly recommended.

Correspondeu às expectativas, chegou na data prevista.

Had broken RCA plug on one of the speakers to the Logitech Z4, with the source of the issue being the wire connection to the RCA plug. As I do not have a soldering iron, this was the easiest fix by stripping out the wire to find the internal left and right, then stripping those down to fit into the new RCA plug (as these are lower end Logitech speaker wires, they fit easily), which you screw into place. And the speaker is working back to normal. To the others having issues with their adapter, I feel mine may be properly be working because the Logitech Z4's structure is the power being sourced directly from the sub, which is pushing a powered output to the speaker alone.