KBS Coatings 4502 Satin Black RustSeal - 1 Gallon

I used this on my saltwater trolling motor. I cleaned all the rust before using this product and the rust is gone. I found that you need to apply very light coats and topcoat it with a UV resistant paint. I used a white Bed liner type spray and love the results.

I bought a 2011 truck recently that had spent enough time in salt that it needed to be taken care of. I sand blasted the frame and a friend at work had recommended KBS. I have never used a product like this. It's almost like it forms a hard shell over the metal, not like just painting it. It came out wonderful and would recommend it to anyone. I am now going to order more and continue up the frame. Word to the wise, use it out of a different container. If you get KBS on the lid of the container, it will not open again. Yes, I made that mistake but this is a minor issue compared to the quality finish you get with this product.

I used this to protect various parts on my 93 Jeep Yj mostly on parts of the frame and bumpers where surface rust had started to form over the years. I prepped all of the surfaces with a wire wheel, phosphoric acid, degreaser, this product, then I top coated the areas that are exposed to direct sun with a black satin spray paint.This product went on easily, covered well, and after a few coats was as hard as a rock. I'm truly impressed.I choose to store this product in a glass mason jar, instead of the original can, it made the cleanup and seal/unseal process much easier. Just clean the lid and make sure the top rim is completely clear of product before sealing it up, good to go.

Really great product. Used on truck frame. Very Happy.

Works good and gives a hard durable surface. Used this on a car trailer frame. I like that it can be brush applied. Bought disposal brushes and mixing cups off Amazon to work out of when painting, then just pitched them when done. Pour out only what you can use in about 10-15 minutes (depends on humidity and temp). Be sure to seal the can as recommended with plastic to prevent the lid sticking. Gave it 4 stars because the galvanized color shows the brush strokes from being applied. I tried thin and thicker single coats. Thin coats showed the brush strokes much more noticeably. Was better with thicker coats but then there was the occasional run. Also tried 2 coats but results were about the same. Looks good from 10 feet away but not as good up close. Did not have this issue with the black color I used previously. It flowed out nice with no noticeable brush strokes or runs.

This paint is extremely durable, would highly recommend for the frame of your off-road vehicle. Only issue is it’s pretty much impossible to save in my experience. You gotta be ready to get the whole job done in 1-2 sessions.

The media could not be loaded. Great product. Covers well. No complaints.

Painted a 6” I beam that was seriously rusted. After cleaning it up and painting it, it not only looks good but it’s sealed very nicely now. Should get many more years out of it.