JIS Crosshead 1/4" Hex Drive Bit

I just received the bits, so it is too early to rate them for durability and sturdiness. Price is fair, so they are rated "good" value for money. Was shipped promptly, properly packaged. One thing to be aware: the bits are not marked with anything. In order to avoid confusion with Phillips bits, I used an electric engraving tool to mark them "JIS" and "1" or "2", as applicable. -Stef B., Bloomington, MN

Good tip. Will not strip out your screw. May be a little more expensive than some other tips on line but will far outlast the others. I use these bits daily and they fit in the screw head better than others.

This bit works so much better with Asian screw heads.Doesn't jump out as often as the US standard ones.

If you work on motorcycles, ATV’s or anything that uses JIS screws. I always wondered what the small dot on the head of screws meant, also why they rounded out so bad.

Fit my ratcheting screwdriver OK. Too small for a standard handheld impact driver.

High quality driver bits for Japanese motorcycles

The JIS standard bit seems to work on all Phillips type screws requiring a #2 size, especially drywall and deck screws. There is no play between the screw and this bit. My only complaint is there is no identification stamp on the bit to differentiate it from other Phillips bits. I use a Dremel tool to engrave JIS on the bits.

Have a 1987 Honda Enduro motorcycle with these JIS screws in a lot of places. These fit well and even worked on some screws where the previous owner buggered them up a little using a regular screwdriver. 5 stars from me

Äntligen kan jag skruva med mina gamla japanska mc

Perfect for JIS screws on Japan motorcycles

Very good,thank you

works great