ARCCAPTAIN 55A Plasma Cutter, Non-Touch Pilot ARC High-Frequency Air Plasma Cutting Machine, 120/240V Dual Voltage IGBT Inverter, 1/2" Clean Cut, Post Flow,2T/4T, and 1/4" - 18 NPT, for Beginners DIY

Works surprisingly well. Does all it is advertised to do.

This is a wonderful beginner plasma cutter. I was skeptical until doing some research and finding out that some are contact start the surface you are cutting has to be bare metal. This one can cut painted and rusted metal which is exactly what I needed. It’s easy to set up and worked perfectly first try. I would recommend this product to anyone looking for a great beginner plasma cutter at a great price!

Pretty darn good for a cheap unit. You Better have a big air compressor and 220v available because it does not like 120v unless it’s on the minimal setting cutting thin metal. it also uses a lot of air. I have a 30 gallon compressor I wouldn’t recommend anything smaller than 15-20 . Light weight very portable cuts through 1/4 inch steel easy and easy to set up. I do wish the air hose was different though

Following directions to connect everything and did some test cuts. Exactly what I need for my auto restoration project! Small and light the ArcCaptain Cut 55 is worth every penny.

It’s a good value if you get a machine that actually works, I literally just got this yesterday and put it together to find out that it has a bad internal ground connection problem. How I found this issue, was whether or not I had the ground connected, it did the same thing. Then to top it off, good luck getting support from ArcCaptain. Tried customer support twice at two different times, no ones available, no call back option. 1star until my issue is resolved