[10-Pack] PROCURU Heavy Duty Angle Stop Valve 1/2" Nominal (5/8" OD) Compression x 3/8" OD, 1/4-Turn Operation (PCAS12-10P)

very good product and heavy duty. They are supper worth. The home builder supper low quality product.

The "[10-Pack] PROCURU Heavy Duty Angle Stop Valve 1/2" Nominal (5/8" OD) Compression x 3/8" OD, 1/4-Turn Operation (PCAS12-10P)" arrived in disarray. The small cardboard box that contained all 10 was not sealed with tape, and during shipment all contents flew out. Fortunately this was the only problem; in all other respects, these angle valves are working great. The valves are made of brass, including the inner ball that rotates. They open and close smoothly, and the lever does not wiggle or feel flimsy in any way. I had a contractor install five of them already, and none of them exhibited any leaks or other problems. The ferrules wrapped onto the copper pipes smoothly. The nuts threaded onto the valves comfortably. All dimensions for connections to inlet and outlet were spot-on. I rate this five stars.

Very durable, easy to install, great price

The durability of the product is very good. It doesn’t have a plastic valve inside. It is a true metal valve, which will not leak for many years. The seal is very good because it is metal versus big box stores selling the plastic ones even though the outside looks metal. The inside is actually plastic. The installation is typical with any type of valve.

Old valve had a drip so you couldn't completely turn it off and it was the old style that required several complete turns before it would shut off, which was not convenient or practical. These are really good and didn't take much effort to install. No leaks. Only "complaint" is they don't seem to flow as much as the old valve. I'd say it's got some built in water restriction and probably flows 70-80% compared to old valve (which might be new "code")

These are solid brass not plastic like some box stores

These angle stops are the best price for 10 that I’ve been able to find. They function well and easy to install. If you have a puller for the washer or in some cases, you can use the old washer if it’s not damaged.

I remodel condominiums built in the mid 80's. Many have shutoff valves that don't close fully and ooze water from the stem. It's quicker and cheaper to replace those valves than to rebuild them. These stop valves are great replacements. It takes about 30 seconds to swap out the old valve body. No need to cut the pipe or replace the compression ring, just screw the new body onto the old compression nut. No drips, no dribbles, no leaks.