Waterproof Motorcycle Cover Replace for Honda Goldwing Without Trunk Model

My Valkyrie Standard has a small Fly Screen windshield, hard saddlebags and no rear rack or passenger saddle. This Cover fits just fine. It is literally 15F. outside in KC, so didn’t jack around much to get the cover fitted!!! The side Grey Reflective stripes basically align with the handgrips, while the lower most front of the Red vinyl aligns with the front tire. There is a single adjustment 1” strap just about where my kickstand lands on pavement. Toss it across and under the bike to the right side, grab it from there and connect to the Buckle Strap just below the Driver Foot Peg. NOW, the diagram shows the lower perimeter seam tension string access to be near the Front Tire. Not so much. Mine was located at the back, near the Rear Tire, just nearly aligned with the Wheel Axle. A better design would have been to have had TWO drawstrings, at both Front and Rear of the cover. At this stage, that’s the only knock I have so far. I did a find a couple of the “adhesive seams” mentioned in the Seller’s description, they appeared to be Clear Tape over a few intersecting seams. But man, I was getting frozen outside and had to rush it along for a closer inspection later on!!! Let’s see what the next few months of brutal Midwest winter and a Tornadic spring can do to it!

I purchased this in September of 2025. It was waterproof for the first 6 months. Now, all the seams leak, so it is not much better than leaving my motorcycle out in the rain. The cover is now about as good as covering my motorcycle with an old sheet; it will keep the sun off it but not the rain.

This is covering a Touring HD and it fits fine with no issues. Recommend