AONOMIRhino 5200 Tape Replace for DYMO 18053 3/8" 9mm Black on White Heat Shrink Tube Labels Compatible with DYMO Rhino 4200, 5200, 5000, 6000 Label Maker,4-Pack

Excellent product!

I just finished using several of these cartridges for rewiring/upgrading our HOA Clubhouse sound and IT systems. I generated the labels using a Dymo Rhino 4200 labeler(another 5 start review to follow). Having retired I don't have access to my former employer's Brady labelers. The product is excellent and far more economical than Dymo's equivalent product. The Brady equivalent is even more expensive. Lettering is sharp and durable.If you haven't used heat-shrink wire labels before try shrinking them by heating on the opposite side of the lettering. Then tighten in up if needed on the letter side. This will make a tight wrinkle free label every time unless the label was too big to begin with. 1/2" works perfectly on standard CAT5 cable. With some of the thicker shielded CAT6's and above you might want to go to 3/4". Shrink wrap labels 1" and below will not fit over any connector.

Overall, I have not been disappointed with with the Aonomi labels or heat shrink tubes. So, begs the question, when is good, good enough. For me, when value meets your needs without compromise. Highly recommended.

I purchased this 1/4" size to use on 14ga automotive wire because I use 1/4" regular heat shrink on it. It barely slides on the wire before heat shrinking. I had to order 3/8 to use on the 14ga this 1/4 is way too small.

When wiring controls and you have 50 red wires this is a must. I only wish I bought an assortment of different sizes.

As an industrial control systems integrator, I constantly use my Rhino label maker for marking wires and cables in the field. The high cost of the Rhino heat-shrink labels was just an unfortunate expense to the projects. I am pleased that these labels give me a cost-effective option to the Rhino products. I have found that they are as good as the Rhino product. Note, that the material is slightly softer than the Rhino labels, and thus it actually shrinks a little bit faster when the heat-gun is applied.

I bought these for a project I was working on. Really did not have high expectations, I just hoped they would feed and print on my label printer.After a test print I was pleased to find better print quality 5hen the actual dymo labels. Labels shrank down nicely and left me a very clean looking labels.I will.be buying this product again.

Seems to work as well as OEM tubing but a lot cheaper

These aftermarket cartridges work great in dymo rhino 5200. Used for labelling electrical Automation panels.

Kann man nichts falsch machen

Works fine with Rhino 5200

Passen nicht im Dymo 6000+

We use the product to label wiring and it does the job just fine. Will reorder when we run low.