[QLED Screen Upgrade] 7" Double Din Car Stereo with Wireless Apple CarPlay and Android Auto, 240W Powerful Sound, 4.2-Channel Audio Output, Bluetooth, MirrorLink, Backup Camera, AM/FM Car Radio

I installed this unit in my 2008 Jeep Wrangler 4dr. Amazon says it won't fit, but it does. A Metra 95-6511 dash kit, Crux SOOCR-26 harness kit and Metra 40-EU10 antenna adapter are required for this application. Installation is not difficult for someone with mechanical experience and a bit of patience to remove the center dash panel. It isn't necessary to completely remove the panel and disconnect all of the climate control switches. Once the panel is loosened by removing two screws at the top and two at the bottom behind the trim panel, it pops out with a little bit of controlled force. I decided to mount the rear camera on top of the license plate holder light fixture. It had to be near the outer end to make room for the LR taillight assembly which must be removed to tap in the power and ground for the camera. Just run the cable behind the holder and through the existing hole in the body into the cavity behind the taillight. The camera cable will be routed up through the rubber grommet under the carpet and then along the edge (also under carpet) past the rear door and front door. Removing the plastic trim panels is required along with replacement plastic clips. Route the cable around behind the brake and accelerator pedals. It is a little difficult to get the camera cable up through the dash into position behind the stereo but I used a flexible fiberglass rod. Once the cable and harness adapter are in place the rest is just connecting the wires as shown in the manual. I used closed end cap connectors then zip tied the bundles together to keep it neat and tucked in. It is recommended that before you go through all of the trouble, first connect just the red and yellow power wire, ground and one speaker (I used green) to make sure the unit is functional and correctly connected to power. If so, you're good to go. After installation, I found that this unit does everything I need it to do. Sound quality is good (I have replaced the Jeep factory speakers with Kicker) and all of the functions work well. Setting up Bluetooth and Android Auto is easy. There are several display settings and everything operates smoothly. Depending upon how you mount the camera, there are settings to change the up/down and L/R orientation. It will probably be necessary to update the firmware after installation. The company website does not have download links for this. You must email them and include a photo of the version screen and a copy of the Amazon invoice and they will send back instructions for the update. A nice added feature is the ability to customize the boot screen with the manufacturer's logo of your car. This is available with the update package. Just tell them what you want. All in all, this appears to be a good choice. Lots of features and a low price point for a vehicle I use as an off-road toy. I've no doubt this unit will do well for a daily driver. Time will tell about the long-term durability but for now, it's all good.

Installed in a 2012 VW GTI to replace the stock head unit. Wanted something with nav and hands-free for my teen driver. Pros: * Everything worked straight out of the box that came with the kit. * The actual installation was quick. (see install notes below. These are not a problem with the head unit, but worth understanding) * The wiring diagram provided is simple to understand . * Works with Android Auto and Carplay with no fuss. * Sound quality is pretty good for the price point. * Controls are easy to understand and the layout of the user interface is logical. Installation notes. Disclaimer: I was expecting almost all of this. You should make sure you do your prep work to make this as easy as possible. This is not a fault with this head unit. It is normal, expected work when installing an aftermerket stereo. * YOU NEED AN ADAPTER HARNESS OR PINOUT FOR YOUR SPECIFIC CAR. This unit is not plug and play without an adapter harness. Especially if your car already has things like cameras, nav and satellite radio. You will need additional modules to fully integrate this head unit (varies by car). Harness varies by application. * You will likely need an adapter bracket to install in a factory opening. I ended up building my own and 3d printing a faceplate to cover the large gap left in the dash. Again, this varies by car make and model. * Spend a little time before you install the unit, crimping spade terminals or some other type of easy disconnect connectors in place. It will make this unit easy to replace or remove in the future if you need to get into the dash. * If you install the rear camera and don't have one already, you will likely have to drill a hole through the body to run the cable. Don't forget to use a grommet to protect the wiring from the sharp edges, and seal it to keep water out.

This Screen is a solid 8.5/10. I’ve have had this screen for about a week now, and I can certainly say that the quality of the stereo system is very good and the price is fair. I am a big fan of the Apple CarPlay and the Reverse camera included in the kit. I am also fond of the clean touchscreen design and high quality feel the stereo has. The radio that comes with the stereo is very efficient and easy to use. I appreciate how the USB cover fits very nicely and doesn’t make the unit look cheap. the product was fairly easy to install; this unit was installed into a 2001 Toyota Tundra limited Access cab. It’s very convenient that everything is automatically uploaded as soon as you connect to Apple CarPlay via USB, unfortunately you cannot do this as easy with the USB C cable. Bluetooth is obviously still an option and once you connect the car kit automatically connects from then on. Lastly, the unit is just clean and high quality and worth the price, the install was easy and I only needed to buy a aftermarket wiring harness additionally when installing this system. All in all, I am very fond with this product and rate it positively. Cons: This unit specifically has some delay. Whenever you click apps, change songs, connect to the CarPlay, basically whenever you do anything there is some delay. The delay is minimal but it’s definitely noticeable and maybe a dealbreaker for someone looking for a flawless clean transition or a high responsive system. It’s kind of annoying that you have to follow a long-ish process to upload a specific logo for the unit boot up screen. When I placed my order I expected it to be fairly easy. I was looking forward at looking at the Toyota logo every time I started my truck, but because I don’t want to go through the process of uploading the logo, I’m Stuck with a low quality image of the company logo. The back up camera has super minimal glitches whenever in use but it does not effect or impair your driving in any way, just a small detail.

Excelente unidad, la pantalla es nítida y responde muy rápido, la conexión a CarPlay es muy rápida, el sonido es muy bueno en el nivel 2 ya suena fuerte! Las cámaras frontal y trasera funcionan muy bien. La conexión es muy sencilla, conecte todo a un amplificador de 6 canales, el ecualizador funciona de maravilla