allpondsolutionsFPP-1500 Fountain Pond Pump Submersible with Fountain Attachment for Outdoor Garden, 1500 Litre/Hour Flow Rate

Got this for my garden pond, works brilliantly, and am very happy with purchase

Good product at a reasonable price . Perfect for my pond. If I were to make a comment the manufacturer could take a look at the attachments that are included in the kit. I had to use some from another project as what I required wasn't in the kit.

A little noisy, but it works fine and pretty good at the price

I have 2 small ponds and wanted to link them both with a stream... this is powerful enough to do the job, just perfect

Case hard to get off (yes even with screw removed !) Also does not seem to have the capacity of a 3500 pump

I needed a pump just to create some movement in a garden pond mostly inhabited by wildlife, to prevent the growth of blanket weed. A previous pump had demised, browsing Amazon this seemed to fit the bill. It arrived almost the next day and was simple to install. Small and light, it is suspended in the water, not touching the bottom and run for a few hours a day on a time switch. When running it is quiet and produces a sprinkling efect (I have left the fountain bit attached) over a metre long. More than enough to disturb the surface. Good value and great service along with plenty of cable.

You need to be very careful where you place this pump, it needs to be in fairly shallow water or raised up on blocks (which only works on level surfaces). The grids on the casing go virtually to the bottom and therefore it sucks up any detritus and makes the pond cloudy. This is probably why people are complaining about filters clogging up quickly. It would be better if the grids were not so low down the sides or there was a 'foot' to lift it up a bit. Designers should be forced to use their products before they go on sale. It is not practical to put it on blocks with a vertical waterfall outlet.I bought this knowing that there were spares available. I was sick of buying kit and then finding there were no spares available when something went wrong. I need it to drive a waterfall. Now I find it is design limitations that are the problem.There is only a (push fit) tee piece attachment with 1" hose to drive the waterfall off the fountain attachment. If you have a larger bore hose fitted to your waterfall this will not connect horizontally from the pump only vertically (as shown). To me this means that my hose sticks out of the water and is very restrictive as to where I can place the pump. I have all sorts of combinations of tees and adaptors from previous pumps but cannot get anything to fit. If the tee piece was screw fit and not push fit to the screwed adaptor the I am sure I could work something out. I know it shows the larger hose-tail connection coming from the top on the pictures but I assumed that the fitting on the front was there for use as well, it is not until you get the leaflet can you see that a sketch showing the hose for filter / waterfall coming out of the top. I cannot fathom the purpose of the front connection as it is blanked off and is directly opposite the pump inlet anyway. There are other pumps from this supplier showing horizontal outlets but not this model.I guess it is going back. I have a ticket in with All Pond Solutions but do not hold out a lot of hope reading some of the comments here.

After no luck with a solar pump, I bought this one for a little half barrel pond and my gosh it has plenty of power.The filter on it also is great. When I first installed the unit the water wasn’t great and not clear at all but after running the pump for a day it’s super clear.You will need to buy a plug for this itemCable is well constructed and very long in comparison to many others. Unit itself is a lot smaller than I thought but has the power needed. Plenty of accessories and options to switch up your set up as you go

va che e' una meraviglia facile da pulire penso ne prendero' un altra da abbinare ad un filtro che e' montato su una vecchia pompa