Edge Supply Birch 1-1/2" X 25 ft Roll, Wood Veneer Edge Banding Preglued, Iron on with Hot Melt Adhesive, Flexible Wood Tape Sanded to Perfection. Easy Application, Made in USA

Works perfectly. Easy to use.

It takes some practice to get it right, but good adhesion. I ended up putting foil over an iron -- sped up the process and kept any extra adhesive off the iron. . Get the cutter to go with it. Looked good and easy to use sealer over it.

This edge banding is easy to work with. The adhesive is good, and holds well. It is stainable, and allows uniform staining, it is not blotchy.

I used this edge banding on a project and worked out fairly well. The birch wood grain is very nice and matches my plywood pretty much exactly. The glue adhered well once ironed on. The one flaw of this banding is that it doesn't absorb wood stain easily or evenly. First, I tried applying a polycrylic clear coat to a sample piece to see if it would match my plywood that had been treated the same. The edge banding was much, much lighter than the plywood--pretty much the same pale color as it looks before the clear coat. By contrast, my plywood deepens to a darker, warmer yellow. So, on another piece I tried applying a very light stain to match (the Minwax "Natural 209"). This did very little. So, to another piece I tried using a darker stain (Varathane "Golden Pecan"), which matched the plywood very well after about three coats. However, the stain was absorbed by the edge banding very unevenly across the length. Some parts of the edge banding absorbed the stain easily while other parts remain relatively unstained. Ultimately, it gave the edges a somewhat blotchy appearance that I'm a little dissatisfied with. This is not a prefinished edge banding, so I'm not sure what's up. If you decide to go with this product, I suggest testing out samples first to make sure that it matches your plywood, before adhering it to your project.

Good product.

Greatest stuff ever for laminating the sides of two 3/4” sheets of plywood. It’s very easy to apply if you have a regular clothes iron, no steam needed. Once it cools the adhesive is stuck on like it’s welded on. Cut any excess off with a box knife, stain using any stain you want, finish using any finish you want and it’s a beautiful thing.

The product looks nice and adheres well. My real issue is that there were six splices in the 25 foot length. Luckily I didn't need all 25 feet and was able to find enough unspliced parts to make it work, but I would be far more unhappy If I would have needed to have a splice show in a critical location. These splices will show up prominently once stained.

This is oversized so you can double up your 3/4” plywood.

Good product

This stuff works so well. I laminated two 3/4 inch pieces of maple ply together to get a 1.5 inch thick counter top, used this to edge the front and it looks seamless. Awesome!

Used to put edge detail onto some diy shelfs. Adhesive worked great.

Facile a utiliser et conforme a mes attentes et besoin

Very poor quality. Insufficient amount of heat melt glue resulting on poor adhesion. Also the veneer is thinner than most other edge trim products resulting in product being very brittle.