Car Key Fob Replacement Fits for Ford Explorer Edge 2011-2015 Expedition Flex Taurus 2013-2019 Focus Escape Lincoln MKS MKT MKX Navigator Keyless Entry Remote Set of Two M3N5WY8609 164-R8092

Received the key fobs quickly , programmed them with a Ford computer and it worked very well. I Would recommend this product for sure.

These fobs work great. I was able to successfully program 2 fobs using my laptop and a licensed software program. I can see how some folks have trouble with the programing if they're not using a dealer or an extended licensed program (F.O.R.S.c.a.n.). I used said program and accessed the key programing section only to find out there where already 3 programed keys. (I bought the vehicle used and it only came with 1 fob). The max allowed is 4. I had to erase all the keys and reprogram my original key and the 2 new ones. Pretty straight forward and inexpensive. Do your homework and you'll be able to obtain the needed program, hardware adapter and extended licensed required to perform the programming relatively cheap. Yes you can still obtain the extended license legitimately even with the current restrictions in place with our neighbors. Again, do some homework and read some forums. I cannot believe how much I saved over taking my vehicle to the dealer. I recommend these fobs 100%.

Bought Two and worked perfect! Easy to program!

Buyer Beware! If your vehicle does not have a key ignition - remote ignition only - these replacements cannot be set up without the help of a dealership or locksmith. I have two remotes and one does not work correctly. I ordered these based on other reviews that made it seem as if it would be easy to set up. IT IS NOT EASY UNLESS YOU HAVE A KEY IGNITION as well as remote.

It took several minutes to realize that I was putting the keys in the wrong spot in my center console, then a couple more to get the timing right on the car's programming sequence, none of which was the fault of the key fobs. They shipped with charged batteries, which I had not taken for granted. The programming sequence I found online was put a new fob in the slot shaped for it in the center console, buttons facing the passenger seat and keyring facing rear. With the car OFF, hit the driver door unlook three times, then pump the break, hit driver door lock three times, pump the break, wait a moment for the ignition button to flash, then press it, then wait until a message comes up on the dashboard near where the (no key detected) message usually appears until it gives the new number of programmed keys, then take the fob out and press unlock on it. The doors should unlock. done. Rinse, repeat with the other fob. Only complaint is that the key ring of the fob is slightly tight, but I can live with that now that I have a working remote start button again just before it gets too cold outside.

I only had one key-less fob which is just dumb so I bought two more of these. I had to take them to the dealership as two programmed fobs must be present or making more doesn't work, so... I do. The system can only hold four programmed keys so all the previous programmed key codes were removed to make the new coded keys. The original working fob was erased as all had to be cleared as well. The Dealership tried to program these new fobs and couldn't make them take the data. The problem then was the system needs two programmable keys and the new ones weren't programmable (GRRR). However, the tech waited and hour and tried programming the keys again and the codes went into the keys successfully. My take on this miracle is prayers work when you need them the most. The keys all work perfectly. WHEW !!

Worked fine after programed by ford

It was easy to set up and works well as long as you are close to the vehicle. Will not lock, unlock or remote start if you are more than 50ft away. However it is a good deal for the price when comparing to the cost at the dealership. Battery didn't last more than a couple of months and needed replaced.