Freedom FPV - Universal Flight Simulator USB Adapter Cable All In One - FlySky FS-i6, FS-i10, Spectrum, JR, Esky, FMS - FPV Freerider, Velocidrone, Liftoff, Hotprops, Aerofly RC, RealFlight, DRL

This was our second such product. The first one was a few bucks cheaper but was flaky and quit working after a day. This one works like a charm. I'm using it on a Flysky fs-i6x. The USB dongle has a slider switch which we placed on the 5th position, "VRC," and the device showed up immediately in linux, we checked it out with 'jstest' (joystick test), and it works great with our simulator software CRRCsim. No complaints.

This worked first try for connecting my RC controller (Jumper T8SG) to my PC running the PhoenixRC simulator. This cable connects the 3.5mm buddy-box port on the controller to the PC's USB. The cable is pretty standard 3.5mm or 1/8" male at both ends, so if you need a longer one, they are easy to find or make. Put the switch on the #1 position and set your transmitter protocol on PPM. Go into PhoenixRC and set up all your control assignments and directions and you are ready to go!

I got this 04-12-2019. It worked just fine for 1 day. when I got it lite up as it should the next day I plugged it into my computer and nothing it did not work. It must be junk. I did nothing wrong. just plugged it in and nothing happened. I am sadly disappointed.

This works great for the Radiolink at9s on many simulators not just the ones listed on the switch. However it only lasted for almost 3 months and was a bit spotty the entire time, I would have to make sure the connections were just right for it to stay working.

solid white light when on and flashes when connected to controller. works fine with my turnigy 9xr and velocidrone. i have the switch on the highest position and put electric tape over the light emitting part to block it out. been using it for about a week with no issues, so i hope it keeps on working but will update otherwise.

The only thing bad is sometimes the plug comes loose from the tx/radio. Other than that it works well. I’m a beginner learning to fly line of sight in acro mode. The learning curve has been quite steep as I crash alot. The simulator I use is so accurate it mirrors the same mistakes I make in the real world. I reccomend this if you want to practice before or along with real world flying.

Plugged it in following the online manual and it worked just as intended. I use a Turnigy 9x and it works smoothly with no issues. Make sure you unplug your radio module and I found that it has to be powered off, apparently the usb connection powers the unit. Highly reccomend.

Can't get this to work. Waste of money.