5 6 7.1/7.2 or 8.1/8.2 One or Two Subwoofer Compatible 16 Banana Post and 2 RCA Speaker Wall Plate for Home Theater Audio

If you go to a local home improvement place, you are lucky if you find anything similar, in fact I couldn't find it, you could only order them and they were not as complete and they were more expensive. This is a quality product, the only thing missing is a mounting bracket, but those are a couple of dollars and no wall plate ever comes with the mounting bracket. You can either connect the wires via twist and lock or you can use banana type connectors, either way, it works perfectly. I would recommend this for any professional grade home installation, even institutional one. My system is 7.1 so I didn't use the center channels, but that is OK because it wired it for maybe a future expansion. But at it stands it sounds perfect.

Feels solid and I don't notice any reduction in audio quality. Nice that there are so many hookups and it's somewhat modular. Be sure to order a mud ring to install with it.

really cleaned up av on remodel

This wall plate is built well and very easy to install and wire. This is a very good solution to concealing your speaker wire and cleaning up the area behind your equipment (receivers, amps etc...) I received it in a timely manner and was not disappointed with the quality of the product.

I used this as an input junction box behind my AV gear rack. The plate itself is well made, and well labeled. Very easy wire up the posts. Very sturdy and neat looking plate. Now my wiring closet looks very clean and no more messy. Thanks for this wall plate.

Very well package and laid out. The product evan pre labled to aid in installation. Very good quality gold plated connectors provide worry free signal trans mission.

I like to wall plate but unless you find a "short shaft" banana plug, pushing it in on the front side will push the back side banana plug out. I recommend using either a spade connection or bare wire on the back side. I have been unable to locate "short shaft" banana plugs

This worked extremely well for a 7.2 setup. I used this during a basement refinish. I ran the speaker cables post framing. I used a 3-gang low voltage box for mounting it (pre dry wall). Once dry walled, used Sewell banana clips on the back to hook up each cable (and tested them). I hate cables, this really helped to consolidate the massive amount of cabling needed for this setup.

Works well. Just a bit snug fitting all the wires on the back. I did use 10 gauge so a little larger diameter made it more difficult.

My banana plugs fit very loose like they fall out