UFO Reloading Press Light for Hornady LnL AP & O Frame Single Stage Presses

This UFO light system is outstanding. I had another, more expensive, lighting system setup on my Hornady LnL AP press and it just wasn't getting the job done. I saw this lighting system on a website for Dillon presses and looked on KMS Squared's website to see if they had it for the Hornady press and they did. The 550 lumens is no joke! It is super bright. I originally thought about keeping both light kits to make sure I had enough light, but the old light kit is not even needed with this awesome UFO light kit. I couldn't even tell the old light kit was turned on next to the UFO light kit. If you want something that will truly light up your shell plate and the inside of your cases during reloading, this is definitely the lighting kit you need to get. I wish I would have gotten this kit initially when I started reloading with my press. It would have made reloading life so much easier! It was also super easy to install and everything you need came with the kit. You didn't even need the instructions to install it, but the instructions are clear and concise. Really folks, if you reload on a press, this is the lighting kit you need to make sure that everything is running in order on your press.

This is a great light! Be careful to read the installation manual and install as directed. The lights have stuck well and have worked great. I guess I didn't prep the surface of the side of the press for the wire stick-em things and they keep falling off. Not a big deal. I'll glue them on with a stronger adhesive.

When I first bought my Hornady Lock N Load progressive press, I picked up an LED light system. It worked OK but did not stay stuck to the slick paint and the roughness of the casting. It was also not too flexible which made it even more difficult to stay in place.When I saw this I quickly noticed that there were more LED lights on it than on my old system. Seeing that it was very thin I also assumed that it would be very flexible. I was correct on both assumptions!Just to insure that it stuck very well I applied a 1 mm thick double sided tape on the press first. The adhesive on the light grabbed and has stayed stuck tight since. Not sure if the double sided tape is needed but just wanted to be sure.This lights up my cases while reloading better than I would have ever expected! They supply everything needed. Zip ties, degreaser wipes are just a bonus. Installation was 10 minutes and I could not be happier!Thank you so much for the great product at a super price!

Great product. Second press light I purchased and both work like a charm

This is actually a great product, and does a very good job of lighting the work area of the press. The Adhesion though was not as good as it should be. I followed instructions but the strip going down to the base kept coming loose. I solved the issue with a couple of zip ties.

lights up the work area very well no more trying to get a flashlight in there trying to look around so in my opinion im very pleased

I’m a big klutz and even I was able to install this with minimal difficulty. The light is bright and shines right where you need it. I highly recommend this product.

The media could not be loaded. Love it, much brighter than I thought it would be. Installation is a bit awkward because of the angle you're working at, but following directions and slightly heating the the Press with a hair dryer and lights by leaving them on after cleaning the press as directed and everything is sticking well. Best addition to my press. Very bright, makes it very easy to see powder levels in charged cases.