JOIKIT2 Pack 0.5 T Cable Grip Wire Puller, Wire Gripper Steel Cable Pulling Tool for 1/32-3/8 Inch Rope,1102 Lbs

I am an amateur radio operator and I used this to replace some ropes I had in trees holding up wire antennas. I decided to replace the ropes which were at risk of abrasion on tree limbs with wire cable. The ropes and cables were under a fair amount of tension and the wire cable was difficult to pull with enough force. These devices worked well not only to pull the cable, but to temporarily hold it in place while I attached hardware to the cable. These are the smallest of 3 sizes sold. The other 2 sizes have a moving plate to secure the cable and keep it from coming out of the clamp. I was concerned that I might have difficulty with the cables slipping out without this side plate, but they did not show any tendency to slip out at all. I don't expect to use them very often but when I need them, they will work like nothing else! I am very pleased with it. I've never seen anything else like this before, so all I can say about the value is that it was worth it to me.Have now been using for 3 months. No problems at all with durability. These are very handy to have

Todo ok

I used this item to remove steel brake lines and gas lines from a 1998 Honda.. Hooked the piece of line I couldn't pull out by hand to cable gripper and the other to a chain and the other end of the chain to my lawn tractor and the tractor ripped the lines right out. Other wise I would have to of left those piece's in the car.

The first time we used cable pullers in our repair shop. They work awesome for door cables.

To big for 4mm wire it slides right through waist of time and money trying to uses wire slides grip is not strong enough for 4mm wire even though it says right on it that it 4mm.don’t waist your money. I would give a zero stars if i could.

Lo trabaje y está muy exelente para mi trabajo