Tuff Coat UT-216 Sand - Submersible, Water-Based, Rubberized Non-Skid Coating - 1 Gallon

Looks great, application is easy. Store roller in air tight bag between coats. I followed the directions meticulously and it turned out great. Applied to 3/16th aluminum boat deck.

good product, easy application, it has a popcorn celling type of finish, very nice

I used this product to protect the boards on my trailer so they don't rot over time because it is left outside. Before applying it, I applied their adhesion primer after pressure washing. It looks great. I am not sure about its durability as it is only been on a few weeks, but it appears that it will stand the test of time. I used the beige color to reflect the sun. The sand like particles in the mix makes it completely non-slip. I would recommend this product, but use their primer and roller to apply properly.

LOOKS LIKE A GOOD PRODUCT

Went down easy and looking good

This stuff is just awful. Almost as bad as their primer. It is without a doubt the thinnest paint I have ever used; and I've painted too many cars and almost everything else at some point or another. So I've used a lot of paint. The best way I could describe it is like a really thin gritty whitewash...like 3/4 gal water/2 egg whites/one drop of tint/1/4 gal grit. First of all there is way too much grit which sinks to the bottom of your solution within a few seconds...you absolutely have to keep rolling from the bottom of the pan to keep the grit in suspension. No matter how hard I tried, I would always wind up with way too much grit in the mix and be left with a thick slurry after a few minutes painting. The worst part is the coverage. I painted (or tried to paint) 45-50 sq ft of smooth surface inside a boat and I had to use the entire gallon just to get any coverage...four full coats as heavy as possible without applying too much grit. And I can still see through it a little, with some bleed-though also. I would have to put another half gallon on there to get good coverage...two more coats over four...for 50 sq ft. That's just crazy!I would think I just got a bad batch but I used their primer first and it was just as thin and even more difficult to use. I feel sorry for inexperienced painters spending so much for these products and trying to figure out how to use them. I'm pretty much stuck with the job I got from Tuff Coat so hopefully it will hold up. Don't make the mistake of trying their products

Love the paint we bought for our boat to paint inside great nonskid . Kimberly Fleming

It's been a year now so I figure I would review it, put this on my pontoon boat with brand new decking last year. Dogs, kids, beach trips etc, parked outside all year, I don't have a complete boat cover for the pontoon, only have furniture covers, and the floor still looks brand new after a little soap and water rinse.It was easy to install, mix well, and roll out. I've always done more layers and thinner coats when painting, that process did not disappoint with this product, it's strong and looks great. Cover everything you don't want this on permanently, it will stick to everything it touches! Spend the time to prep your painting area, the clean up is 5x longer then preparation.